<< Chapter < Page Chapter >> Page >
Digital communication systems offer much more efficiency, better performance, and much greater flexibility.

Analog communication systems, amplitude modulation (AM) radio being a typifying example, caninexpensively communicate a bandlimited analog signal from one location to another (point-to-point communication) or from onepoint to many (broadcast). Although it is not shown here, the coherent receiver provides the largest possible signal-to-noise ratio for the demodulated message. An analysis of this receiver thus indicates that some residual error will always be present in an analog system's output.

Although analog systems are less expensive in many cases than digital ones for the same application,digital systems offer much more efficiency, better performance, and much greaterflexibility.

  • Efficiency : The Source Coding Theorem allows quantification of just how complex a givenmessage source is and allows us to exploit that complexity by source coding (compression). In analog communication,the only parameters of interest are message bandwidth and amplitude. We cannot exploit signal structure to achieve amore efficient communication system.
  • Performance : Because of the Noisy Channel Coding Theorem, we have a specific criterion by which toformulate error-correcting codes that can bring us as close to error-free transmission as we might want. Even though wemay send information by way of a noisy channel, digital schemes are capable of error-free transmission while analogones cannot overcome channel disturbances; see this problem for a comparison.
  • Flexibility : Digital communication systems can transmit real-valued discrete-time signals, which couldbe analog ones obtained by analog-to-digital conversion, and symbolic-valued ones (computer data, for example). Any signal that can be transmitted byanalog means can be sent by digital means, with the only issue being the number of bits used in A/D conversion (howaccurately do we need to represent signal amplitude). Images can be sent by analog means (commercial television),but better communication performance occurs when we use digital systems (HDTV). In addition to digitalcommunication's ability to transmit a wider variety of signals than analog systems, point-to-point digital systemscan be organized into global (and beyond as well) systems that provide efficient and flexible informationtransmission. Computer networks , explored in the next section, are what we call such systemstoday. Even analog-based networks, such as the telephone system, employ modern computer networking ideas rather thanthe purely analog systems of the past.
Consequently, with the increased speed of digital computers, thedevelopment of increasingly efficient algorithms, and the ability to interconnect computers to form a communicationsinfrastructure, digital communication is now the best choice for many situations.

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Fundamentals of electrical engineering i. OpenStax CNX. Aug 06, 2008 Download for free at http://legacy.cnx.org/content/col10040/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Fundamentals of electrical engineering i' conversation and receive update notifications?

Ask