<< Chapter < Page Chapter >> Page >
Describes line-of-sight communication.

Long-distance transmission over either kind of channel encounters attenuation problems. Losses in wireline channelsare explored in the Circuit Models module , where repeaters can extend the distance between transmitter and receiver beyond what passive losses thewireline channel imposes. In wireless channels, not only does radiation loss occur , but also one antenna may not "see" another because of the earth's curvature.

Two antennae are shown each having the same height. Line-of-sight transmission means the transmitting andreceiving antennae can "see" each other as shown. The maximum distance at which they can see each other, d LOS , occurs when the sighting line just grazes the earth's surface.

At the usual radio frequencies, propagating electromagnetic energy does not follow the earth's surface. Line-of-sight communication has the transmitter and receiver antennas in visual contact with each other. Assumingboth antennas have height h above the earth's surface, maximum line-of-sight distance is

d LOS 2 2 h R h 2 2 2 R h
where R is the earth's radius ( 6.38 6 m ).

Derive the expression of line-of-sight distance using only the Pythagorean Theorem. Generalize it to the case where theantennas have different heights (as is the case with commercial radio and cellular telephone). What is the rangeof cellular telephone where the handset antenna has essentially zero height?

Use the Pythagorean Theorem, h R 2 R 2 d 2 , where h is the antenna height, d is the distance from the top of the earth to a tangency point withthe earth's surface, and R the earth's radius. The line-of-sight distance between twoearth-based antennae equals

d LOS 2 h 1 R h 1 2 2 h 2 R h 2 2
As the earth's radius is much larger than the antenna height, we have to a good approximation that d LOS 2 h 1 R 2 h 2 R . If one antenna is at ground elevation, say h 2 0 , the other antenna's range is 2 h 1 R .

Got questions? Get instant answers now!

Can you imagine a situation wherein global wireless communication is possible with only one transmittingantenna? In particular, what happens to wavelength when carrier frequency decreases?

As frequency decreases, wavelength increases and can approach the distance between the earth's surface and theionosphere. Assuming a distance between the two of 80 km, the relation λ f c gives a corresponding frequency of 3.75 kHz. Such low carrier frequencies would be limited to low bandwidth analogcommunication and to low datarate digital communications. The US Navy did use such a communicationscheme to reach all of its submarines at once.

Got questions? Get instant answers now!

Using a 100 m antenna would provide line-of-sight transmission over a distance of 71.4 km. Using such very tall antennas wouldprovide wireless communication within a town or between closely spaced population centers. Consequently, networks of antennas sprinkle the countryside (each located on the highest hill possible) to provide long-distance wirelesscommunications: Each antenna receives energy from one antenna and retransmits to another. This kind of network is known as a relay network .

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Fundamentals of electrical engineering i. OpenStax CNX. Aug 06, 2008 Download for free at http://legacy.cnx.org/content/col10040/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Fundamentals of electrical engineering i' conversation and receive update notifications?

Ask