<< Chapter < Page Chapter >> Page >
By the end of this section, you will be able to:
  • Determine the angular frequency of oscillation for a resistor, inductor, capacitor ( R L C ) series circuit
  • Relate the R L C circuit to a damped spring oscillation

When the switch is closed in the RLC circuit    of [link] (a), the capacitor begins to discharge and electromagnetic energy is dissipated by the resistor at a rate i 2 R . With U given by [link] , we have

d U d t = q C d q d t + L i d i d t = i 2 R

where i and q are time-dependent functions. This reduces to

L d 2 q d t 2 + R d q d t + 1 C q = 0 .
Figure a is a circuit with a capacitor, an inductor and a resistor in series with each other. They are also in series with a switch, which is open. Figure b shows the graph of charge versus time. The charge is at maximum value, q0, at t=0. The curve is similar to a sine wave that reduces in amplitude till it becomes zero.
(a) An RLC circuit. Electromagnetic oscillations begin when the switch is closed. The capacitor is fully charged initially. (b) Damped oscillations of the capacitor charge are shown in this curve of charge versus time, or q versus t . The capacitor contains a charge q 0 before the switch is closed.

This equation is analogous to

m d 2 x d t 2 + b d x d t + k x = 0 ,

which is the equation of motion for a damped mass-spring system (you first encountered this equation in Oscillations ). As we saw in that chapter, it can be shown that the solution to this differential equation takes three forms, depending on whether the angular frequency of the undamped spring is greater than, equal to, or less than b /2 m . Therefore, the result can be underdamped ( k / m > b / 2 m ) , critically damped ( k / m = b / 2 m ) , or overdamped ( k / m < b / 2 m ) . By analogy, the solution q ( t ) to the RLC differential equation has the same feature. Here we look only at the case of under-damping. By replacing m by L , b by R , k by 1/ C , and x by q in [link] , and assuming 1 / L C > R / 2 L , we obtain

q ( t ) = q 0 e R t / 2 L cos ( ω t + ϕ )

where the angular frequency of the oscillations is given by

ω = 1 L C ( R 2 L ) 2

This underdamped solution is shown in [link] (b). Notice that the amplitude of the oscillations decreases as energy is dissipated in the resistor. [link] can be confirmed experimentally by measuring the voltage across the capacitor as a function of time. This voltage, multiplied by the capacitance of the capacitor, then gives q ( t ).

Try an interactive circuit construction kit that allows you to graph current and voltage as a function of time. You can add inductors and capacitors to work with any combination of R , L , and C circuits with both dc and ac sources.

Try out a circuit-based java applet website that has many problems with both dc and ac sources that will help you practice circuit problems.

Check Your Understanding In an RLC circuit, L = 5.0 mH , C = 6.0 μ F , and R = 200 Ω . (a) Is the circuit underdamped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0 × 10 −3 C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?

a. overdamped; b. 0.75 J

Got questions? Get instant answers now!

Summary

  • The underdamped solution for the capacitor charge in an RLC circuit is
    q ( t ) = q 0 e R t / 2 L cos ( ω t + ϕ ) .
  • The angular frequency given in the underdamped solution for the RLC circuit is
    ω = 1 L C ( R 2 L ) 2 .

Key equations

Mutual inductance by flux M = N 2 Φ 21 I 1 = N 1 Φ 12 I 2
Mutual inductance in circuits ε 1 = M d I 2 d t
Self-inductance in terms of magnetic flux N Φ m = L I
Self-inductance in terms of emf ε = L d I d t
Self-inductance of a solenoid L solenoid = μ 0 N 2 A l
Self-inductance of a toroid L toroid = μ 0 N 2 h 2 π ln R 2 R 1 .
Energy stored in an inductor U = 1 2 L I 2
Current as a function of time for a RL circuit I ( t ) = ε R ( 1 e t / τ L )
Time constant for a RL circuit τ L = L / R
Charge oscillation in LC circuits q ( t ) = q 0 cos ( ω t + ϕ )
Angular frequency in LC circuits ω = 1 L C
Current oscillations in LC circuits i ( t ) = ω q 0 sin ( ω t + ϕ )
Charge as a function of time in RLC circuit q ( t ) = q 0 e R t / 2 L cos ( ω t + ϕ )
Angular frequency in RLC circuit ω = 1 L C ( R 2 L ) 2

Questions & Answers

how do you get the 2/50
Abba Reply
number of sport play by 50 student construct discrete data
Aminu Reply
width of the frangebany leaves on how to write a introduction
Theresa Reply
Solve the mean of variance
Veronica Reply
Step 1: Find the mean. To find the mean, add up all the scores, then divide them by the number of scores. ... Step 2: Find each score's deviation from the mean. ... Step 3: Square each deviation from the mean. ... Step 4: Find the sum of squares. ... Step 5: Divide the sum of squares by n – 1 or N.
kenneth
what is error
Yakuba Reply
Is mistake done to something
Vutshila
Hy
anas
hy
What is the life teble
anas
hy
Jibrin
statistics is the analyzing of data
Tajudeen Reply
what is statics?
Zelalem Reply
how do you calculate mean
Gloria Reply
diveving the sum if all values
Shaynaynay
let A1,A2 and A3 events be independent,show that (A1)^c, (A2)^c and (A3)^c are independent?
Fisaye Reply
what is statistics
Akhisani Reply
data collected all over the world
Shaynaynay
construct a less than and more than table
Imad Reply
The sample of 16 students is taken. The average age in the sample was 22 years with astandard deviation of 6 years. Construct a 95% confidence interval for the age of the population.
Aschalew Reply
Bhartdarshan' is an internet-based travel agency wherein customer can see videos of the cities they plant to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400 a. what is the probability of getting more than 12,000 hits? b. what is the probability of getting fewer than 9,000 hits?
Akshay Reply
Bhartdarshan'is an internet-based travel agency wherein customer can see videos of the cities they plan to visit. The number of hits daily is a normally distributed random variable with a mean of 10,000 and a standard deviation of 2,400. a. What is the probability of getting more than 12,000 hits
Akshay
1
Bright
Sorry i want to learn more about this question
Bright
Someone help
Bright
a= 0.20233 b=0.3384
Sufiyan
a
Shaynaynay
How do I interpret level of significance?
Mohd Reply
It depends on your business problem or in Machine Learning you could use ROC- AUC cruve to decide the threshold value
Shivam
how skewness and kurtosis are used in statistics
Owen Reply
yes what is it
Taneeya
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 1

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 2. OpenStax CNX. Oct 06, 2016 Download for free at http://cnx.org/content/col12074/1.3
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 2' conversation and receive update notifications?

Ask