<< Chapter < Page Chapter >> Page >
This chapter discusses measuring descriptive statistical information using the center of the data

The "center" of a data set is also a way of describing location. The two most widely used measures of the "center" of the data are the mean (average) and the median . To calculate the mean weight of 50 people, add the 50 weights together and divide by 50. To find the median weight of the 50 people, order the data and find the number that splits the data into two equal parts (previously discussed under box plots in this chapter). The median is generally a better measure of the center when there are extreme values or outliers because it is not affected by the precise numerical values of the outliers. The mean is the most common measure of the center.

The words "mean" and "average" are often used interchangeably. The substitution of one word for the other is common practice. The technical term is "arithmetic mean" and "average" is technically a center location. However, in practice among non-statisticians, "average" is commonly accepted for "arithmetic mean."

The mean can also be calculated by multiplying each distinct value by its frequency and then dividing the sum by the total number of data values. The letter used to represent the sample mean is an x with a bar over it (pronounced " x bar"): x .

The Greek letter μ (pronounced "mew") represents the population mean. One of the requirements for the sample mean to be a good estimate of the population mean is for the sample taken to be truly random.

To see that both ways of calculating the mean are the same, consider the sample:

  • 1
  • 1
  • 1
  • 2
  • 2
  • 3
  • 4
  • 4
  • 4
  • 4
  • 4

x ¯ = 1 + 1 + 1 + 2 + 2 + 3 + 4 + 4 + 4 + 4 + 4 11 = 2.7
x ¯ = 3 × 1 + 2 × 2 + 1 × 3 + 5 × 4 11 = 2.7

In the second calculation for the sample mean, the frequencies are 3, 2, 1, and 5.

You can quickly find the location of the median by using the expression n + 1 2 .

The letter n is the total number of data values in the sample. If n is an odd number, the median is the middle value of the ordered data (ordered smallest to largest). If n is an even number, the median is equal to the two middle values added together and divided by 2 after the data has been ordered. For example, if the total number of data values is 97, then n + 1 2 = 97 + 1 2 = 49 . The median is the 49th value in the ordered data. If the total number of data values is 100, then n + 1 2 = 100 + 1 2 = 50.5 . The median occurs midway between the 50th and 51st values. The location of the median and the value of the median are not the same. The upper case letter M is often used to represent the median. The next example illustrates the location of the median and the value of the median.

AIDS data indicating the number of months an AIDS patient lives after taking a new antibody drug are as follows (smallest to largest):

  • 3
  • 4
  • 8
  • 8
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 15
  • 16
  • 16
  • 17
  • 17
  • 18
  • 21
  • 22
  • 22
  • 24
  • 24
  • 25
  • 26
  • 26
  • 27
  • 27
  • 29
  • 29
  • 31
  • 32
  • 33
  • 33
  • 34
  • 34
  • 35
  • 37
  • 40
  • 44
  • 44
  • 47

Calculate the mean and the median.

The calculation for the mean is:

x ¯ = [ 3 + 4 + ( 8 ) ( 2 ) + 10 + 11 + 12 + 13 + 14 + ( 15 ) ( 2 ) + ( 16 ) ( 2 ) + ... + 35 + 37 + 40 + ( 44 ) ( 2 ) + 47 ] 40 = 23.6

To find the median, M , first use the formula for the location. The location is:

n + 1 2 = 40 + 1 2 = 20.5

Starting at the smallest value, the median is located between the 20th and 21st values (the two 24s):

  • 3
  • 4
  • 8
  • 8
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 15
  • 16
  • 16
  • 17
  • 17
  • 18
  • 21
  • 22
  • 22
  • 24
  • 24
  • 25
  • 26
  • 26
  • 27
  • 27
  • 29
  • 29
  • 31
  • 32
  • 33
  • 33
  • 34
  • 34
  • 35
  • 37
  • 40
  • 44
  • 44
  • 47

M = 24 + 24 2 = 24

The median is 24.

Using the ti-83,83+,84, 84+ calculators

Calculator Instructions are located in the menu item 14:Appendix (Notes for the TI-83, 83+, 84, 84+ Calculators).
  • Enter data into the list editor. Press STAT 1:EDIT
  • Put the data values in list L1.
  • Press STAT and arrow to CALC. Press 1:1-VarStats. Press 2nd 1 for L1 and ENTER.
  • Press the down and up arrow keys to scroll.
x ¯ = 23.6 , M = 24

Suppose that, in a small town of 50 people, one person earns $5,000,000 per year and the other 49 each earn $30,000. Which is the better measure of the "center," the mean or the median?

x ¯ = 5000000 + 49 × 30000 50 = 129400

M = 30000

(There are 49 people who earn $30,000 and one person who earns $5,000,000.)

The median is a better measure of the "center" than the mean because 49 of the values are 30,000 and one is 5,000,000. The 5,000,000 is an outlier. The 30,000 gives us a better sense of the middle of the data.

Another measure of the center is the mode. The mode is the most frequent value. If a data set has two values that occur the same number of times, then the set is bimodal.

Statistics exam scores for 20 students are as follows

Statistics exam scores for 20 students are as follows:

  • 50
  • 53
  • 59
  • 59
  • 63
  • 63
  • 72
  • 72
  • 72
  • 72
  • 72
  • 76
  • 78
  • 81
  • 83
  • 84
  • 84
  • 84
  • 90
  • 93

Find the mode.

The most frequent score is 72, which occurs five times. Mode = 72.

Five real estate exam scores are 430, 430, 480, 480, 495. The data set is bimodal because the scores 430 and 480 each occur twice.

When is the mode the best measure of the "center"? Consider a weight loss program that advertises a mean weight loss of six pounds the first week of the program. The mode might indicate that most people lose two pounds the first week, making the program less appealing.

The mode can be calculated for qualitative data as well as for quantitative data.

Statistical software will easily calculate the mean, the median, and the mode. Some graphing calculators can also make these calculations. In the real world, people make these calculations using software.

The law of large numbers and the mean

The Law of Large Numbers says that if you take samples of larger and larger size from any population, then the mean x ¯ of the sample is very likely to get closer and closer to µ . This is discussed in more detail in The Central Limit Theorem .

The formula for the mean is located in the Summary of Formulas section course.

Sampling distributions and statistic of a sampling distribution

You can think of a sampling distribution as a relative frequency distribution with a great many samples. (See Sampling and Data for a review of relative frequency). Suppose thirty randomly selected students were asked the number of movies they watched the previous week. The results are in the relative frequency table shown below.

# of movies Relative Frequency
0 5/30
1 15/30
2 6/30
3 4/30
4 1/30

If you let the number of samples get very large (say, 300 million or more), the relative frequency table becomes a relative frequency distribution .

A statistic is a number calculated from a sample. Statistic examples include the mean, the median and the mode as well as others. The sample mean x ¯ is an example of a statistic which estimates the population mean μ .

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Collaborative statistics-parzen remix. OpenStax CNX. Jul 15, 2009 Download for free at http://legacy.cnx.org/content/col10732/1.2
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Collaborative statistics-parzen remix' conversation and receive update notifications?

Ask