1. Home
  2. University physics volume 2
  3. Unit 2. electricity and magnetism
  4. Alternating-current circuits
  5. Power in an ac circuit

15.4 Power in an ac circuit  (Page 2/4)

<< Chapter < Page
  University physics volume 2     Page 2 / 4
Chapter >> Page >

Alternating voltages and currents are usually described in terms of their rms values. For example, the 110 V from a household outlet is an rms value. The amplitude of this source is 110 2 V = 156 V . Because most ac meters are calibrated in terms of rms values, a typical ac voltmeter placed across a household outlet will read 110 V.

For a capacitor and an inductor, ϕ = π / 2 and − π / 2 rad, respectively. Since cos π / 2 = cos ( − π / 2 ) = 0 , we find from [link] that the average power dissipated by either of these elements is P ave = 0 . Capacitors and inductors absorb energy from the circuit during one half-cycle and then discharge it back to the circuit during the other half-cycle. This behavior is illustrated in the plots of [link] , (b) and (c), which show p( t) oscillating sinusoidally about zero.

The phase angle for an ac generator may have any value. If cos ϕ > 0 , the generator produces power; if cos ϕ < 0 , it absorbs power. In terms of rms values, the average power of an ac generator is written as

P ave = I rms V rms cos ϕ .

For the generator in an RLC circuit,

tan ϕ = X L − X C R

and

cos ϕ = R R 2 + ( X L − X C ) 2 = R Z .

Hence the average power of the generator is

P ave = I rms V rms cos ϕ = V rms Z V rms R Z = V rms 2 R Z 2 .

This can also be written as

P ave = I rms 2 R ,

which designates that the power produced by the generator is dissipated in the resistor. As we can see, Ohm’s law for the rms ac is found by dividing the rms voltage by the impedance.

Power output of a generator

An ac generator whose emf is given by

v ( t ) = ( 4.00 V ) sin [ ( 1.00 × 10 4 rad / s ) t ]

is connected to an RLC circuit for which L = 2.00 × 10 −3 H , C = 4.00 × 10 −6 F , and R = 5.00 Ω . (a) What is the rms voltage across the generator? (b) What is the impedance of the circuit? (c) What is the average power output of the generator?

Strategy

The rms voltage is the amplitude of the voltage times 1 / 2 . The impedance of the circuit involves the resistance and the reactances of the capacitor and the inductor. The average power is calculated by [link] , or more specifically, the last part of the equation, because we have the impedance of the circuit Z , the rms voltage V rms , and the resistance R .

Solution

  1. Since V 0 = 4.00 V, the rms voltage across the generator is
    V rms = 1 2 ( 4.00 V ) = 2.83 V .
  2. The impedance of the circuit is
    Z = R 2 + ( X L − X C ) 2 = { ( 5.00 Ω ) 2 + [ ( 1.00 × 10 4 rad/s ) ( 2.00 × 10 −3 H ) − 1 ( 1.00 × 10 4 rad/s ) ( 4.00 × 10 −6 F ) ] 2 } 1 / 2 = 7.07 Ω .
  3. From [link] , the average power transferred to the circuit is
    P ave = V rms 2 R Z 2 = ( 2.83 V ) 2 ( 5.00 Ω ) ( 7.07 Ω ) 2 = 0.801 W .

Significance

If the resistance is much larger than the reactance of the capacitor or inductor, the average power is a dc circuit equation of P = V 2 / R , where V replaces the rms voltage.

Got questions? Get instant answers now!

Check Your Understanding An ac voltmeter attached across the terminals of a 45-Hz ac generator reads 7.07 V. Write an expression for the emf of the generator.

v ( t ) = ( 10.0 V ) sin 90 π t

Got questions? Get instant answers now!

Check Your Understanding Show that the rms voltages across a resistor, a capacitor, and an inductor in an ac circuit where the rms current is I rms are given by I rms R , I rms X C , and I rms X L , respectively. Determine these values for the components of the RLC circuit of [link] .

2.00 V; 10.01 V; 8.01 V

Got questions? Get instant answers now!

Summary

  • The average ac power is found by multiplying the rms values of current and voltage.
  • Ohm’s law for the rms ac is found by dividing the rms voltage by the impedance.
  • In an ac circuit, there is a phase angle between the source voltage and the current, which can be found by dividing the resistance by the impedance.
  • The average power delivered to an RLC circuit is affected by the phase angle.
  • The power factor ranges from –1 to 1.

Conceptual questions

For what value of the phase angle ϕ between the voltage output of an ac source and the current is the average power output of the source a maximum?

Got questions? Get instant answers now!

Discuss the differences between average power and instantaneous power.

The instantaneous power is the power at a given instant. The average power is the power averaged over a cycle or number of cycles.

Got questions? Get instant answers now!

The average ac current delivered to a circuit is zero. Despite this, power is dissipated in the circuit. Explain.

Got questions? Get instant answers now!

Can the instantaneous power output of an ac source ever be negative? Can the average power output be negative?

The instantaneous power can be negative, but the power output can’t be negative.

Got questions? Get instant answers now!

The power rating of a resistor used in ac circuits refers to the maximum average power dissipated in the resistor. How does this compare with the maximum instantaneous power dissipated in the resistor?

Got questions? Get instant answers now!

Problems

The emf of an ac source is given by v ( t ) = V 0 sin ω t , where V 0 = 100 V and ω = 200 π rad/s . Calculate the average power output of the source if it is connected across (a) a 20 - μ F capacitor, (b) a 20-mH inductor, and (c) a 50 - Ω resistor.

Got questions? Get instant answers now!

Calculate the rms currents for an ac source is given by v ( t ) = V 0 sin ω t , where V 0 = 100 V and ω = 200 π rad/s when connected across (a) a 20 - μ F capacitor, (b) a 20-mH inductor, and (c) a 50 - Ω resistor.

a. 0.89 A; b. 5.6A; c. 1.4 A

Got questions? Get instant answers now!

A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC voltmeter is placed across the inductor, what does it read?

Got questions? Get instant answers now!

For an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500 Hz, respectively; R = 500 Ω ; and L = 0.20 H . Find the average power dissipated in the resistor for the following values for the capacitance: (a) C = 2.0 μ F and (b) C = 0.20 μ F .

a. 7.3 W; b. 6.3 W

Got questions? Get instant answers now!

An ac source of voltage amplitude 10 V delivers electric energy at a rate of 0.80 W when its current output is 2.5 A. What is the phase angle ϕ between the emf and the current?

Got questions? Get instant answers now!

An RLC series circuit has an impedance of 60 Ω and a power factor of 0.50, with the voltage lagging the current. (a) Should a capacitor or an inductor be placed in series with the elements to raise the power factor of the circuit? (b) What is the value of the capacitance or self-inductance that will raise the power factor to unity?

a. inductor; b. X L = 52 Ω

Got questions? Get instant answers now!

Questions & Answers

how to study physic and understand
Ewa Reply
what is conservative force with examples
Moses
what is work
Fredrick Reply
the transfer of energy by a force that causes an object to be displaced; the product of the component of the force in the direction of the displacement and the magnitude of the displacement
AI-Robot
why is it from light to gravity
Esther Reply
difference between model and theory
Esther
Is the ship moving at a constant velocity?
Kamogelo Reply
The full note of modern physics
aluet Reply
introduction to applications of nuclear physics
aluet Reply
the explanation is not in full details
Moses Reply
I need more explanation or all about kinematics
Moses
yes
zephaniah
I need more explanation or all about nuclear physics
aluet
Show that the equal masses particles emarge from collision at right angle by making explicit used of fact that momentum is a vector quantity
Muhammad Reply
yh
Isaac
A wave is described by the function D(x,t)=(1.6cm) sin[(1.2cm^-1(x+6.8cm/st] what are:a.Amplitude b. wavelength c. wave number d. frequency e. period f. velocity of speed.
Majok Reply
what is frontier of physics
Somto Reply
A body is projected upward at an angle 45° 18minutes with the horizontal with an initial speed of 40km per second. In hoe many seconds will the body reach the ground then how far from the point of projection will it strike. At what angle will the horizontal will strike
Gufraan Reply
Suppose hydrogen and oxygen are diffusing through air. A small amount of each is released simultaneously. How much time passes before the hydrogen is 1.00 s ahead of the oxygen? Such differences in arrival times are used as an analytical tool in gas chromatography.
Ezekiel Reply
please explain
Samuel
what's the definition of physics
Mobolaji Reply
what is physics
Nangun Reply
the science concerned with describing the interactions of energy, matter, space, and time; it is especially interested in what fundamental mechanisms underlie every phenomenon
AI-Robot
what is isotopes
Nangun Reply
nuclei having the same Z and different N s
AI-Robot
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
<< Chapter < Page Page > Chapter >>
Practice Key Terms 2

Read also:

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 2. OpenStax CNX. Oct 06, 2016 Download for free at http://cnx.org/content/col12074/1.3
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 2' conversation and receive update notifications?

Ask