<< Chapter < Page Chapter >> Page >

You should have found this formula:

λ = 2 L n - 1

Here, n is the number of nodes. L is the length of the string. The frequency f is:

f = v λ

Here, v is the velocity of the wave. This may seem confusing. The wave is a standing wave, so how can it have a velocity? But one standing wave is made up of many waves that travel back and forth on the string.Each of these waves has the same velocity. This speed depends on the mass and tension of the string.

We have a standing wave on a string that is 65 cm long. The wave has a velocity of 143 m.s - 1 . Find the frequencies of the fundamental, first, second, and third harmonics.

  1. L = 65 cm = 0 . 65 m v = 143 m . s - 1 f = ?

    To find the frequency we will use f = v λ

  2. To find f we need the wavelength of each harmonic ( λ = 2 L n - 1 ). The wavelength is then substituted into f = v λ to find the harmonics. The table below shows the calculations.

    110 Hz is the natural frequency of the A string on a guitar. The third harmonic, at 440 Hz, is the note that orchestras use for tuning.

Got questions? Get instant answers now!


Guitars use strings with high tension. The length, tension and mass of the strings affect the pitches you hear.High tension and short strings make high frequencies; low tension and long strings make low frequencies. When a string is first plucked, it vibrates at many frequencies.All of these except the harmonics are quickly filtered out. The harmonics make up the tone we hear.

The body of a guitar acts as a large wooden soundboard. Here is how a soundboard works: the body picks up the vibrations of the strings. It then passes these vibrations to the air.A sound hole allows the soundboard of the guitar to vibrate more freely. It also helps sound waves to get out of the body.

The neck of the guitar has thin metal bumps on it called frets. Pressing a string against a fret shortens the length of that string.This raises the natural frequency and the pitch of that string.

Most guitars use an "equal tempered" tuning of 12 notes per octave. A 6 string guitar has a range of 4 1 2 octaves with pitches from 82.407 Hz (low E) to 2093 kHz (high C). Harmonics may reach over 20 kHz, in the inaudible range.


Let us look at another stringed instrument: the piano. The piano has strings that you cannot see. When a key is pressed, a felt-tipped hammer hits astring inside the piano. The pitch depends on the length, tension and mass of the string. But there are many more strings than keys on a piano. This is because the short and thinstrings are not as loud as the long and heavy strings. To make up for this, the higher keys have groups of two to four strings each.

The soundboard in a piano is a large cast iron plate. It picks up vibrations from the strings. This heavy plate can withstand over 200 tons of pressure from string tension!Its mass also allows the piano to sustain notes for long periods of time.

The piano has a wide frequency range, from 27,5 Hz (low A) to 4186,0 Hz (upper C). But these are just the fundamental frequencies. A piano plays complex,rich tones with over 20 harmonics per note. Some of these are out of the range of human hearing. Very low piano notes can be heard mostly because of their higher harmonics.

Questions & Answers

states the Newton's second law of motion
Shallin Reply
In words it says:" when a net force is applied to an object of mass, It accelerates in the direction of the net force. The acceleration is directly proportional to the net force and inversely proportional to the mass".
And in symbols: Fnet = ma
thank you
how does hydrogen bonds differ from London force
Madzivha Reply
how come the resultant force is 0
Andrew Reply
It's when you have equivalent forces going different directions then your resultant will be equal to zero
describe what john's experiment proves about water molecules?
Fanozi Reply
Newton's first law of motion
Ayabonga Reply
am great n u
An unknown gas has pressure,volume and temprature of 0.9atm,and 120°C.how many moles of gas are present?
Chrislyn Reply
Can you, if possible send me more quizzes
Bradley Reply
What is selmon
heath Reply
how long it takes for 25ml ethanol to be evaporated?
Kgaugelo Reply
how to calculate acceleration
Sphe Reply
It depends
Please state the Newton third low
Newton's Third law states that to every force applied, there's an equal but opposite reaction
difference between a head and tail methods
Zenande Reply
difference between a head-to-tail and tail-to-tail
head to tail you draw each vector starting head of the previous vector and tail to tail you construct a parallelogram whereas you started the two vectors from the same axis(from their tails)and the diagonal between the vectors is the resultant vector,tail to tail only includes two vectors
what is a normal force
Zenande Reply
a normal force is the force that the surface applies on the object. The force is perpendicular to the surface.
Lewis structure for C2H2
Mthokozisi Reply
what is the mathematical relationship between velocity and time?
Oyisa Reply
How do we find a resulted force of a vector
Dann-boy Reply

Get the best Siyavula textbooks: gr... course in your pocket!

Source:  OpenStax, Siyavula textbooks: grade 11 physical science. OpenStax CNX. Jul 29, 2011 Download for free at http://cnx.org/content/col11241/1.2
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Siyavula textbooks: grade 11 physical science' conversation and receive update notifications?