<< Chapter < Page Chapter >> Page >

Shown below is a small ball of mass m attached to a string of length a . A small peg is located a distance h below the point where the string is supported. If the ball is released when the string is horizontal, show that h must be greater than 3 a /5 if the ball is to swing completely around the peg.

A small ball is shown attached to a string of length a. A small peg is located a distance h below the point where the string is supported. The ball is released when the string is horizontal  and swings in a circular arc.

proof

Got questions? Get instant answers now!

A block leaves a frictionless inclined surfarce horizontally after dropping off by a height h . Find the horizontal distance D where it will land on the floor, in terms of h , H , and g .

A block is shown at rest at the top of a ramp, a vertical distance h above a horizontal platform. The platform is a distance H above the floor. The block is shows to be moving horizontally to the right with speed v on the platform and to land on the floor a horizontal distance D from where it drops off the platform.
Got questions? Get instant answers now!

A block of mass m , after sliding down a frictionless incline, strikes another block of mass M that is attached to a spring of spring constant k (see below). The blocks stick together upon impact and travel together. (a) Find the compression of the spring in terms of m , M , h , g , and k when the combination comes to rest. (b) The loss of kinetic energy as a result of the bonding of the two masses upon impact is stored in the so-called binding energy of the two masses. Calculate the binding energy.

A block of mass m is shown at the top of a downward sloping ramp. The block is a vertical distance h above the ground and is at rest (v=0.) To the right of the ramp, on the horizontal ground, is a mass M attached to  a horizontal spring. The far end of the spring is attached to a wall.

a. 2 m 2 g h k ( m + M ) ; b. m M g h m + M

Got questions? Get instant answers now!

A block of mass 300 g is attached to a spring of spring constant 100 N/m. The other end of the spring is attached to a support while the block rests on a smooth horizontal table and can slide freely without any friction. The block is pushed horizontally till the spring compresses by 12 cm, and then the block is released from rest. (a) How much potential energy was stored in the block-spring support system when the block was just released? (b) Determine the speed of the block when it crosses the point when the spring is neither compressed nor stretched. (c) Determine the speed of the block when it has traveled a distance of 20 cm from where it was released.

Got questions? Get instant answers now!

Consider a block of mass 0.200 kg attached to a spring of spring constant 100 N/m. The block is placed on a frictionless table, and the other end of the spring is attached to the wall so that the spring is level with the table. The block is then pushed in so that the spring is compressed by 10.0 cm. Find the speed of the block as it crosses (a) the point when the spring is not stretched, (b) 5.00 cm to the left of point in (a), and (c) 5.00 cm to the right of point in (a).

a. 2.24 m / s ; b. 1.94 m / s ; c. 1.94 m / s

Got questions? Get instant answers now!

A skier starts from rest and slides downhill. What will be the speed of the skier if he drops by 20 meters in vertical height? Ignore any air resistance (which will, in reality, be quite a lot), and any friction between the skis and the snow.

Got questions? Get instant answers now!

Repeat the preceding problem, but this time, suppose that the work done by air resistance cannot be ignored. Let the work done by the air resistance when the skier goes from A to B along the given hilly path be −2000 J. The work done by air resistance is negative since the air resistance acts in the opposite direction to the displacement. Supposing the mass of the skier is 50 kg, what is the speed of the skier at point B ?

18 m/s

Got questions? Get instant answers now!

Two bodies are interacting by a conservative force. Show that the mechanical energy of an isolated system consisting of two bodies interacting with a conservative force is conserved. ( Hint : Start by using Newton’s third law and the definition of work to find the work done on each body by the conservative force.)

Got questions? Get instant answers now!

In an amusement park, a car rolls in a track as shown below. Find the speed of the car at A , B , and C . Note that the work done by the rolling friction is zero since the displacement of the point at which the rolling friction acts on the tires is momentarily at rest and therefore has a zero displacement.

A roller coaster track with three hills is shown. The first hill is the tallest at 50 meters above the ground, the second is the smallest, and the third hill is of intermediate height at 40 meters above the ground. The car starts with v = 0 at the top of the first hill. Point A is the low point between the second and third hill, 20 meters above the ground. Point B is at the top of the third hill, 40 meters above the ground. Point C is at the ground near the end of the track.

v A = 24 m/s; v B = 14 m/s; v C = 31 m/s

Got questions? Get instant answers now!

A 200-g steel ball is tied to a 2.00-m “massless” string and hung from the ceiling to make a pendulum, and then, the ball is brought to a position making a 30 ° angle with the vertical direction and released from rest. Ignoring the effects of the air resistance, find the speed of the ball when the string (a) is vertically down, (b) makes an angle of 20 ° with the vertical and (c) makes an angle of 10 ° with the vertical.

Got questions? Get instant answers now!

A hockey puck is shot across an ice-covered pond. Before the hockey puck was hit, the puck was at rest. After the hit, the puck has a speed of 40 m/s. The puck comes to rest after going a distance of 30 m. (a) Describe how the energy of the puck changes over time, giving the numerical values of any work or energy involved. (b) Find the magnitude of the net friction force.

a. Loss of energy is 240 N · m ; b. F = 8 N

Got questions? Get instant answers now!

A projectile of mass 2 kg is fired with a speed of 20 m/s at an angle of 30 ° with respect to the horizontal. (a) Calculate the initial total energy of the projectile given that the reference point of zero gravitational potential energy at the launch position. (b) Calculate the kinetic energy at the highest vertical position of the projectile. (c) Calculate the gravitational potential energy at the highest vertical position. (d) Calculate the maximum height that the projectile reaches. Compare this result by solving the same problem using your knowledge of projectile motion.

Got questions? Get instant answers now!

An artillery shell is fired at a target 200 m above the ground. When the shell is 100 m in the air, it has a speed of 100 m/s. What is its speed when it hits its target? Neglect air friction.

89.7 m/s

Got questions? Get instant answers now!

How much energy is lost to a dissipative drag force if a 60-kg person falls at a constant speed for 15 meters?

Got questions? Get instant answers now!

A box slides on a frictionless surface with a total energy of 50 J. It hits a spring and compresses the spring a distance of 25 cm from equilibrium. If the same box with the same initial energy slides on a rough surface, it only compresses the spring a distance of 15 cm, how much energy must have been lost by sliding on the rough surface?

32 J

Got questions? Get instant answers now!
Practice Key Terms 2

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 1. OpenStax CNX. Sep 19, 2016 Download for free at http://cnx.org/content/col12031/1.5
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 1' conversation and receive update notifications?

Ask