Use the equation for heat transfer
to express the heat lost by the aluminum pan in terms of the mass of the pan, the specific heat of aluminum, the initial temperature of the pan, and the final temperature:
Express the heat gained by the water in terms of the mass of the water, the specific heat of water, the initial temperature of the water and the final temperature:
Note that
and
and that they must sum to zero because the heat lost by the hot pan must be the same as the heat gained by the cold water:
This an equation for the unknown final temperature,
Bring all terms involving
on the left hand side and all other terms on the right hand side. Solve for
,
and insert the numerical values:
Discussion
This is a typical
calorimetry problem—two bodies at different temperatures are brought in contact with each other and exchange heat until a common temperature is reached. Why is the final temperature so much closer to
than
? The reason is that water has a greater specific heat than most common substances and thus undergoes a small temperature change for a given heat transfer. A large body of water, such as a lake, requires a large amount of heat to increase its temperature appreciably. This explains why the temperature of a lake stays relatively constant during a day even when the temperature change of the air is large. However, the water temperature does change over longer times (e.g., summer to winter).
Take-home experiment: temperature change of land and water
What heats faster, land or water?
To study differences in heat capacity:
Place equal masses of dry sand (or soil) and water at the same temperature into two small jars. (The average density of soil or sand is about 1.6 times that of water, so you can achieve approximately equal masses by using
more water by volume.)
Heat both (using an oven or a heat lamp) for the same amount of time.
Record the final temperature of the two masses.
Now bring both jars to the same temperature by heating for a longer period of time.
Remove the jars from the heat source and measure their temperature every 5 minutes for about 30 minutes.
Which sample cools off the fastest? This activity replicates the phenomena responsible for land breezes and sea breezes.
If 25 kJ is necessary to raise the temperature of a block from
to
, how much heat is necessary to heat the block from
to
?
The heat transfer depends only on the temperature difference. Since the temperature differences are the same in both cases, the same 25 kJ is necessary in the second case.
The transfer of heat
that leads to a change
in the temperature of a body with mass
is
, where
is the specific heat of the material. This relationship can also be considered as the definition of specific heat.
Questions & Answers
material that allows electric current to pass through
the transfer of energy by a force that causes an object to be displaced; the product of the component of the force in the direction of the displacement and the magnitude of the displacement
A wave is described by the function D(x,t)=(1.6cm) sin[(1.2cm^-1(x+6.8cm/st] what are:a.Amplitude b. wavelength c. wave number d. frequency e. period f. velocity of speed.
A body is projected upward at an angle 45° 18minutes with the horizontal with an initial speed of 40km per second. In hoe many seconds will the body reach the ground then how far from the point of projection will it strike. At what angle will the horizontal will strike
Suppose hydrogen and oxygen are diffusing through air. A small amount of each is released simultaneously. How much time passes before the hydrogen is 1.00 s ahead of the oxygen? Such differences in arrival times are used as an analytical tool in gas chromatography.
the science concerned with describing the interactions of energy, matter, space, and time; it is especially interested in what fundamental mechanisms underlie every phenomenon