<< Chapter < Page Chapter >> Page >

Calculating current: using kirchhoff’s rules

Find the currents flowing in the circuit in [link] .

The diagram shows a complex circuit with two voltage sources E sub one and E sub two and several resistive loads, wired in two loops and two junctions. Several points on the diagram are marked with letters a through h. The current in each branch is labeled separately.
This circuit is similar to that in [link] , but the resistances and emfs are specified. (Each emf is denoted by script E.) The currents in each branch are labeled and assumed to move in the directions shown. This example uses Kirchhoff’s rules to find the currents.

Strategy

This circuit is sufficiently complex that the currents cannot be found using Ohm’s law and the series-parallel techniques—it is necessary to use Kirchhoff’s rules. Currents have been labeled I 1 size 12{I rSub { size 8{1} } } {} , I 2 size 12{I rSub { size 8{2} } } {} , and I 3 size 12{I rSub { size 8{3} } } {} in the figure and assumptions have been made about their directions. Locations on the diagram have been labeled with letters a through h. In the solution we will apply the junction and loop rules, seeking three independent equations to allow us to solve for the three unknown currents.

Solution

We begin by applying Kirchhoff’s first or junction rule at point a. This gives

I 1 = I 2 + I 3 , size 12{I rSub { size 8{1} } =I rSub { size 8{2} } +I rSub { size 8{3} } } {}

since I 1 size 12{I rSub { size 8{1} } } {} flows into the junction, while I 2 size 12{I rSub { size 8{2} } } {} and I 3 size 12{I rSub { size 8{3} } } {} flow out. Applying the junction rule at e produces exactly the same equation, so that no new information is obtained. This is a single equation with three unknowns—three independent equations are needed, and so the loop rule must be applied.

Now we consider the loop abcdea. Going from a to b, we traverse R 2 size 12{R rSub { size 8{2} } } {} in the same (assumed) direction of the current I 2 size 12{I rSub { size 8{2} } } {} , and so the change in potential is I 2 R 2 size 12{ - I rSub { size 8{2} } R rSub { size 8{2} } } {} . Then going from b to c, we go from to +, so that the change in potential is + emf 1 size 12{+"emf" rSub { size 8{1} } } {} . Traversing the internal resistance r 1 size 12{r rSub { size 8{1} } } {} from c to d gives I 2 r 1 size 12{ - I rSub { size 8{2} } r rSub { size 8{1} } } {} . Completing the loop by going from d to a again traverses a resistor in the same direction as its current, giving a change in potential of I 1 R 1 size 12{ - I rSub { size 8{1} } R rSub { size 8{1} } } {} .

The loop rule states that the changes in potential sum to zero. Thus,

I 2 R 2 + emf 1 I 2 r 1 I 1 R 1 = I 2 ( R 2 + r 1 ) + emf 1 I 1 R 1 = 0 . size 12{ - I rSub { size 8{2} } R rSub { size 8{2} } +"emf" rSub { size 8{1} } - I rSub { size 8{2} } r rSub { size 8{1} } - I rSub { size 8{1} } R rSub { size 8{1} } = - I rSub { size 8{2} } \( R rSub { size 8{2} } +r rSub { size 8{1} } \) +"emf" rSub { size 8{1} } - I rSub { size 8{1} } R rSub { size 8{1} } =0} {}

Substituting values from the circuit diagram for the resistances and emf, and canceling the ampere unit gives

3 I 2 + 18 6 I 1 = 0 . size 12{ - 3I rSub { size 8{2} } +"18" - 6I rSub { size 8{1} } =0} {}

Now applying the loop rule to aefgha (we could have chosen abcdefgha as well) similarly gives

+ I 1 R 1 + I 3 R 3 + I 3 r 2 emf 2 = + I 1 R 1 + I 3 R 3 + r 2 emf 2 = 0 . size 12{+I rSub { size 8{1} } R rSub { size 8{1} } +I rSub { size 8{3} } R rSub { size 8{3} } +I rSub { size 8{3} } r rSub { size 8{2} } - "emf" rSub { size 8{2} } "=+"I rSub { size 8{1} } R rSub { size 8{1} } +I rSub { size 8{3} } left (R rSub { size 8{3} } +r rSub { size 8{2} } right ) - "emf" rSub { size 8{2} } =0} {}

Note that the signs are reversed compared with the other loop, because elements are traversed in the opposite direction. With values entered, this becomes

+ 6 I 1 + 2 I 3 45 = 0 . size 12{+6I rSub { size 8{1} } +2I rSub { size 8{3} } - "45"=0} {}

These three equations are sufficient to solve for the three unknown currents. First, solve the second equation for I 2 size 12{I rSub { size 8{2} } } {} :

I 2 = 6 2 I 1 . size 12{I rSub { size 8{2} } =6 - 2I rSub { size 8{1} } } {}

Now solve the third equation for I 3 size 12{I rSub { size 8{3} } } {} :

I 3 = 22 . 5 3 I 1 . size 12{I rSub { size 8{3} } ="22" "." 5 - 3I rSub { size 8{1} } } {}

Substituting these two new equations into the first one allows us to find a value for I 1 size 12{I rSub { size 8{1} } } {} :

I 1 = I 2 + I 3 = ( 6 2 I 1 ) + ( 22 . 5 3 I 1 ) = 28 . 5 5 I 1 . size 12{I rSub { size 8{1} } =I rSub { size 8{2} } +I rSub { size 8{3} } = \( 6 - 2I rSub { size 8{1} } \) + \( "22" "." 5 - 3I rSub { size 8{1} } \) ="28" "." 5 - 5I rSub { size 8{1} } } {}

Combining terms gives

6 I 1 = 28 . 5, and size 12{6I rSub { size 8{1} } ="28" "." 5} {}
I 1 = 4 . 75 A . size 12{I rSub { size 8{1} } =4 "." "75"" A"} {}

Substituting this value for I 1 size 12{I rSub { size 8{1} } } {} back into the fourth equation gives

I 2 = 6 2 I 1 = 6 9.50 size 12{I rSub { size 8{2} } =6 - 2I rSub { size 8{1} } =6 - 9 "." "50"} {}
I 2 = 3 . 50 A . size 12{I rSub { size 8{2} } = - 3 "." "50"" A"} {}

The minus sign means I 2 size 12{I rSub { size 8{2} } } {} flows in the direction opposite to that assumed in [link] .

Finally, substituting the value for I 1 size 12{I rSub { size 8{1} } } {} into the fifth equation gives

I 3 = 22.5 3 I 1 = 22.5 14 . 25 size 12{I rSub { size 8{3} } ="22" "." 5 - 3I rSub { size 8{1} } ="22" "." 5 - "14" "." "25"} {}
I 3 = 8 . 25 A . size 12{I rSub { size 8{3} } =8 "." "25"" A"} {}

Discussion

Just as a check, we note that indeed I 1 = I 2 + I 3 size 12{I rSub { size 8{1} } =I rSub { size 8{2} } +I rSub { size 8{3} } } {} . The results could also have been checked by entering all of the values into the equation for the abcdefgha loop.

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 4

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask