<< Chapter < Page Chapter >> Page >
  • Explain the forces exerted by muscles.
  • State how a bad posture causes back strain.
  • Discuss the benefits of skeletal muscles attached close to joints.
  • Discuss various complexities in the real system of muscles, bones, and joints.

Muscles, bones, and joints are some of the most interesting applications of statics. There are some surprises. Muscles, for example, exert far greater forces than we might think. [link] shows a forearm holding a book and a schematic diagram of an analogous lever system. The schematic is a good approximation for the forearm, which looks more complicated than it is, and we can get some insight into the way typical muscle systems function by analyzing it.

Muscles can only contract, so they occur in pairs. In the arm, the biceps muscle is a flexor—that is, it closes the limb. The triceps muscle is an extensor that opens the limb. This configuration is typical of skeletal muscles, bones, and joints in humans and other vertebrates. Most skeletal muscles exert much larger forces within the body than the limbs apply to the outside world. The reason is clear once we realize that most muscles are attached to bones via tendons close to joints, causing these systems to have mechanical advantages much less than one. Viewing them as simple machines, the input force is much greater than the output force, as seen in [link] .

A forearm of a person holding a physics book is shown. The biceps and triceps muscles of the arm are visible. The elbow joint is the pivot point. The upper part of the arm is vertical and the lower part is horizontal. Biceps muscles are applying a force F B upward. The vertical bone of hand exerts a force F E on the pivot. At the midpoint of the lower part of the hand, the center of gravity of the hand is shown where the weight of the hand acts. The midpoint of the front face of the book is its center of gravity, where its weight acts downward. A free body diagram is also shown and the distances of the three forces F-B, C-G of arm, and C-G of book from the pivot are shown as r one, r two and r three.
(a) The figure shows the forearm of a person holding a book. The biceps exert a force F B to support the weight of the forearm and the book. The triceps are assumed to be relaxed. (b) Here, you can view an approximately equivalent mechanical system with the pivot at the elbow joint as seen in [link] .

Muscles exert bigger forces than you might think

Calculate the force the biceps muscle must exert to hold the forearm and its load as shown in [link] , and compare this force with the weight of the forearm plus its load. You may take the data in the figure to be accurate to three significant figures.

Strategy

There are four forces acting on the forearm and its load (the system of interest). The magnitude of the force of the biceps is F B size 12{F rSub { size 8{B} } } {} ; that of the elbow joint is F E size 12{F rSub { size 8{E} } } {} ; that of the weights of the forearm is w a size 12{w rSub { size 8{a} } } {} , and its load is w b size 12{w rSub { size 8{b} } } {} . Two of these are unknown ( F B size 12{F rSub { size 8{B} } } {} and F E size 12{F rSub { size 8{E} } } {} ), so that the first condition for equilibrium cannot by itself yield F B size 12{F rSub { size 8{B} } } {} . But if we use the second condition and choose the pivot to be at the elbow, then the torque due to F E size 12{F rSub { size 8{E} } } {} is zero, and the only unknown becomes F B size 12{F rSub { size 8{B} } } {} .

Solution

The torques created by the weights are clockwise relative to the pivot, while the torque created by the biceps is counterclockwise; thus, the second condition for equilibrium net τ = 0 size 12{ left ("net "τ rSub { size 8{"cw"} } ="net "τ rSub { size 8{"ccw"} } right )} {} becomes

r 2 w a + r 3 w b = r 1 F B . size 12{r rSub { size 8{2} } w rSub { size 8{a} } +r rSub { size 8{3} } w rSub { size 8{b} } =r rSub { size 8{1} } F rSub { size 8{B} } } {}

Note that sin θ = 1 size 12{"sin"θ=1} {} for all forces, since θ = 90º size 12{θ="90"°} {} for all forces. This equation can easily be solved for F B size 12{F rSub { size 8{B} } } {} in terms of known quantities, yielding

F B = r 2 w a + r 3 w b r 1 . size 12{F rSub { size 8{B} } = { {r rSub { size 8{2} } w rSub { size 8{a} } +r rSub { size 8{3} } w rSub { size 8{b} } } over {r rSub { size 8{1} } } } } {}

Entering the known values gives

F B = 0 . 160 m 2 . 50 kg 9 . 80 m/s 2 + 0 . 380 m 4 . 00 kg 9 . 80 m/s 2 0 . 0400 m size 12{F rSub { size 8{B} } = { { left (0 "." "16"" m" right ) left (2 "." "50"" kg" right ) left (9 "." "80"" m/s" rSup { size 8{2} } right )+ left (0 "." "38"" m" right ) left (4 "." "00"" kg" right ) left (9 "." "80"" m/s" rSup { size 8{2} } right )} over {0 "." "04"" m"} } } {}

which yields

F B = 470 N . size 12{F rSub { size 8{B} } ="470"" N"} {}

Now, the combined weight of the arm and its load is 6.50 kg 9.80 m/s 2 = 63.7 N size 12{ left (6 "." "50"`"kg" right ) left (9 "." "80"`"m/s" rSup { size 8{2} } right )="63" "." 7`N} {} , so that the ratio of the force exerted by the biceps to the total weight is

F B w a + w b = 470 63 . 7 = 7 . 38 . size 12{ { {F rSub { size 8{B} } } over {w rSub { size 8{a} } +w rSub { size 8{b} } } } = { {"470"} over {"63" "." 7} } =7 "." "38"} {}

Discussion

This means that the biceps muscle is exerting a force 7.38 times the weight supported.

Got questions? Get instant answers now!

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics. OpenStax CNX. Jul 27, 2015 Download for free at http://legacy.cnx.org/content/col11406/1.9
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics' conversation and receive update notifications?

Ask