<< Chapter < Page Chapter >> Page >
qE = qvB size 12{ ital "qE"= ital "qvB"} {}

or

E = vB . size 12{E= ital "vB"} {}

Note that the electric field E size 12{E} {} is uniform across the conductor because the magnetic field B size 12{B} {} is uniform, as is the conductor. For a uniform electric field, the relationship between electric field and voltage is E = ε / l size 12{E=ε/l} {} , where l size 12{l} {} is the width of the conductor and ε size 12{ε} {} is the Hall emf. Entering this into the last expression gives

ε l = vB . size 12{ { {ε} over {l} } = ital "vB" "." } {}

Solving this for the Hall emf yields

ε = Blv ( B , v , and l , mutually perpendicular ) , size 12{ε= ital "Blv"``` \( B,`v,`"and"`l,`"mutually perpendicular" \) ,} {}

where ε size 12{ε} {} is the Hall effect voltage across a conductor of width l size 12{l} {} through which charges move at a speed v size 12{v} {} .

Diagram showing an electron moving to the left in a three-dimensional rectangular space with velocity v. The magnetic field is oriented out of the page. The electric field is down. The electric force on the charge is up while the magnetic force on the charge is down. An illustration of the right hand rule shows the thumb pointing to the left with v, the fingers out of the page with B, and the force on a positive charge up and away from the palm.
The Hall emf ε size 12{ε} {} produces an electric force that balances the magnetic force on the moving charges. The magnetic force produces charge separation, which builds up until it is balanced by the electric force, an equilibrium that is quickly reached.

One of the most common uses of the Hall effect is in the measurement of magnetic field strength B size 12{B} {} . Such devices, called Hall probes , can be made very small, allowing fine position mapping. Hall probes can also be made very accurate, usually accomplished by careful calibration. Another application of the Hall effect is to measure fluid flow in any fluid that has free charges (most do). (See [link] .) A magnetic field applied perpendicular to the flow direction produces a Hall emf ε size 12{ε} {} as shown. Note that the sign of ε size 12{ε} {} depends not on the sign of the charges, but only on the directions of B size 12{B} {} and v size 12{v} {} . The magnitude of the Hall emf is ε = Blv size 12{ε= ital "Blv"} {} , where l size 12{l} {} is the pipe diameter, so that the average velocity v size 12{v} {} can be determined from ε size 12{ε} {} providing the other factors are known.

Diagram showing a tube with diameter l with one end between the north and south poles of a magnet. The charges are moving with velocity v within the tube and out of the page. The magnetic field B is oriented across the tube, from the north to the south pole of the magnet. The force on the charges is up for positive charges and down for negative charges. e m f = B l v.
The Hall effect can be used to measure fluid flow in any fluid having free charges, such as blood. The Hall emf ε size 12{ε} {} is measured across the tube perpendicular to the applied magnetic field and is proportional to the average velocity v size 12{v} {} .

Calculating the hall emf: hall effect for blood flow

A Hall effect flow probe is placed on an artery, applying a 0.100-T magnetic field across it, in a setup similar to that in [link] . What is the Hall emf, given the vessel’s inside diameter is 4.00 mm and the average blood velocity is 20.0 cm/s?

Strategy

Because B size 12{B} {} , v size 12{v} {} , and l size 12{l} {} are mutually perpendicular, the equation ε = Blv size 12{ε= ital "Blv"} {} can be used to find ε size 12{ε} {} .

Solution

Entering the given values for B size 12{B} {} , v size 12{v} {} , and l size 12{l} {} gives

ε = Blv = 0.100 T 4 . 00 × 10 3 m 0 .200 m/s = 80.0 μV alignl { stack { size 12{ε= ital "Blv"= left (0 "." "100"`T right ) left (4 "." "00" times "10" rSup { size 8{ - 3} } `m right ) left (0 "." "200"`"m/s" right )} {} #="80" "." 0`"μV" {} } } {}

Discussion

This is the average voltage output. Instantaneous voltage varies with pulsating blood flow. The voltage is small in this type of measurement. ε size 12{ε} {} is particularly difficult to measure, because there are voltages associated with heart action (ECG voltages) that are on the order of millivolts. In practice, this difficulty is overcome by applying an AC magnetic field, so that the Hall emf is AC with the same frequency. An amplifier can be very selective in picking out only the appropriate frequency, eliminating signals and noise at other frequencies.

Got questions? Get instant answers now!

Test prep for ap courses

An airplane wingspan can be approximated as a conducting rod of length 35 m. As the airplane flies due north, it is flying at a rate of 82 m/s through the Earth’s magnetic field, which has a magnitude of 45 μT toward the north in a direction 57° below the horizontal plane. (a) Which end of the wingspan is positively charged, the east or west end? Explain. (b) What is the Hall emf along the wingspan?

Got questions? Get instant answers now!

Section summary

  • The Hall effect is the creation of voltage ε size 12{ε} {} , known as the Hall emf, across a current-carrying conductor by a magnetic field.
  • The Hall emf is given by
    ε = Blv ( B , v , and l , mutually perpendicular ) size 12{ε= ital "Blv"``` \( B,`v,`"and"`l,`"mutually perpendicular" \) } {}
    for a conductor of width l size 12{l} {} through which charges move at a speed v size 12{v} {} .

Conceptual questions

Discuss how the Hall effect could be used to obtain information on free charge density in a conductor. (Hint: Consider how drift velocity and current are related.)

Got questions? Get instant answers now!

Problems&Exercises

A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall voltage produced if the pipe runs perpendicular to the Earth’s 5 . 00 × 10 5 -T size 12{5 "." "00" times "10" rSup { size 8{ - 5} } "-T"} {} field.

7 . 50 × 10 4 V

Got questions? Get instant answers now!

What Hall voltage is produced by a 0.200-T field applied across a 2.60-cm-diameter aorta when blood velocity is 60.0 cm/s?

Got questions? Get instant answers now!

(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60-V Hall voltage between its wing tips when in level flight over the north magnetic pole, where the Earth’s field strength is 8 . 00 × 10 5 T? size 12{8 "." "00" times "10" rSup { size 8{ - 5} } `"T?"} {} (b) Explain why very little current flows as a result of this Hall voltage.

(a) 1.18 × 10 3 m/s

(b) Once established, the Hall emf pushes charges one direction and the magnetic force acts in the opposite direction resulting in no net force on the charges. Therefore, no current flows in the direction of the Hall emf. This is the same as in a current-carrying conductor—current does not flow in the direction of the Hall emf.

Got questions? Get instant answers now!

A nonmechanical water meter could utilize the Hall effect by applying a magnetic field across a metal pipe and measuring the Hall voltage produced. What is the average fluid velocity in a 3.00-cm-diameter pipe, if a 0.500-T field across it creates a 60.0-mV Hall voltage?

Got questions? Get instant answers now!

Calculate the Hall voltage induced on a patient’s heart while being scanned by an MRI unit. Approximate the conducting path on the heart wall by a wire 7.50 cm long that moves at 10.0 cm/s perpendicular to a 1.50-T magnetic field.

11.3 mV

Got questions? Get instant answers now!

A Hall probe calibrated to read 1 . 00 μV size 12{1 "." "00"`"μV"} {} when placed in a 2.00-T field is placed in a 0.150-T field. What is its output voltage?

Got questions? Get instant answers now!

Using information in [link] , what would the Hall voltage be if a 2.00-T field is applied across a 10-gauge copper wire (2.588 mm in diameter) carrying a 20.0-A current?

1. 16 μV size 12{1 "." "47"`"μV"} {}

Got questions? Get instant answers now!

Show that the Hall voltage across wires made of the same material, carrying identical currents, and subjected to the same magnetic field is inversely proportional to their diameters. (Hint: Consider how drift velocity depends on wire diameter.)

Got questions? Get instant answers now!

A patient with a pacemaker is mistakenly being scanned for an MRI image. A 10.0-cm-long section of pacemaker wire moves at a speed of 10.0 cm/s perpendicular to the MRI unit’s magnetic field and a 20.0-mV Hall voltage is induced. What is the magnetic field strength?

2.00 T

Got questions? Get instant answers now!
Practice Key Terms 2

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, College physics for ap® courses. OpenStax CNX. Nov 04, 2016 Download for free at https://legacy.cnx.org/content/col11844/1.14
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics for ap® courses' conversation and receive update notifications?

Ask