A pure
LC circuit with negligible resistance oscillates at
, the same resonant frequency as an
RLC circuit. It can serve as a frequency standard or clock circuit—for example, in a digital wristwatch. With a very small resistance, only a very small energy input is necessary to maintain the oscillations. The circuit is analogous to a car with no shock absorbers. Once it starts oscillating, it continues at its natural frequency for some time.
[link] shows the analogy between an
LC circuit and a mass on a spring.
Phet explorations: circuit construction kit (ac+dc), virtual lab
Build circuits with capacitors, inductors, resistors and AC or DC voltage sources, and inspect them using lab instruments such as voltmeters and ammeters.
Section summary
The AC analogy to resistance is impedance
, the combined effect of resistors, inductors, and capacitors, defined by the AC version of Ohm’s law:
where
is the peak current and
is the peak source voltage.
Impedance has units of ohms and is given by
.
The resonant frequency
, at which
, is
In an AC circuit, there is a phase angle
between source voltage
and the current
, which can be found from
for a purely resistive circuit or an
RLC circuit at resonance.
The average power delivered to an
RLC circuit is affected by the phase angle and is given by
is called the power factor, which ranges from 0 to 1.
Conceptual questions
Does the resonant frequency of an AC circuit depend on the peak voltage of the AC source? Explain why or why not.
Suppose you have a motor with a power factor significantly less than 1. Explain why it would be better to improve the power factor as a method of improving the motor’s output, rather than to increase the voltage input.
An
RL circuit consists of a
resistor and a
3.00 mH inductor. (a) Find its impedance
at 60.0 Hz and 10.0 kHz. (b) Compare these values of
with those found in
[link] in which there was also a capacitor.
(a)
at 60.0 Hz,
at 10.0 kHz
(b) At 60 Hz, with a capacitor,
, over 13 times as high as without the capacitor. The capacitor makes a large difference at low frequencies. At 10 kHz, with a capacitor
, about the same as without the capacitor. The capacitor has a smaller effect at high frequencies.
An
RC circuit consists of a
resistor and a
capacitor. (a) Find its impedance at 60.0 Hz and 10.0 kHz. (b) Compare these values of
with those found in
[link] , in which there was also an inductor.
An
LC circuit consists of a
inductor and a
capacitor. (a) Find its impedance at 60.0 Hz and 10.0 kHz. (b) Compare these values of
with those found in
[link] in which there was also a resistor.
(a)
at 60.0 Hz,
at 10.0 kHz
(b) These values are close to those obtained in
[link] because at low frequency the capacitor dominates and at high frequency the inductor dominates. So in both cases the resistor makes little contribution to the total impedance.
To receive AM radio, you want an
RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed
inductor connected to a variable capacitor. What range of capacitance is needed?
Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and capacitors ranging from 1.00 pF to 0.100 F. What is the range of resonant frequencies that can be achieved from combinations of a single inductor and a single capacitor?
The lowest frequency in the FM radio band is 88.0 MHz. (a) What inductance is needed to produce this resonant frequency if it is connected to a 2.50 pF capacitor? (b) The capacitor is variable, to allow the resonant frequency to be adjusted to as high as 108 MHz. What must the capacitance be at this frequency?
An
RLC series circuit has a
resistor, a
inductor, and an
capacitor.(a) Find the circuit’s impedance at 120 Hz. (b) Find the circuit’s impedance at 5.00 kHz. (c) If the voltage source has
, what is
at each frequency? (d) What is the resonant frequency of the circuit? (e) What is
at resonance?
An
RLC series circuit has a
resistor, a
inductor, and a 25.0 nF capacitor. (a) Find the circuit’s impedance at 500 Hz. (b) Find the circuit’s impedance at 7.50 kHz. (c) If the voltage source has
, what is
at each frequency? (d) What is the resonant frequency of the circuit? (e) What is
at resonance?
An
RLC series circuit has a
resistor, a
inductor, and an
capacitor. (a) Find the power factor at
. (b) What is the phase angle at 120 Hz? (c) What is the average power at 120 Hz? (d) Find the average power at the circuit’s resonant frequency.
An
RLC series circuit has a
resistor, a
inductor, and a 25.0 nF capacitor. (a) Find the power factor at
. (b) What is the phase angle at this frequency? (c) What is the average power at this frequency? (d) Find the average power at the circuit’s resonant frequency.
An
RLC series circuit has a
resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is
. (a) What is the impedance? (b) Find the circuit’s capacitance. (c) If
is applied, what is the average power supplied?
Communication is effective because it allows individuals to share ideas, thoughts, and information with others.
effective communication can lead to improved outcomes in various settings, including personal relationships, business environments, and educational settings. By communicating effectively, individuals can negotiate effectively, solve problems collaboratively, and work towards common goals.
it starts up serve and return practice/assessments.it helps find voice talking therapy also assessments through relaxed conversation.
miss
Every time someone flushes a toilet in the apartment building, the person begins to jumb back automatically after hearing the flush, before the water temperature changes. Identify the types of learning, if it is classical conditioning identify the NS, UCS, CS and CR. If it is operant conditioning, identify the type of consequence positive reinforcement, negative reinforcement or punishment
nature is an hereditary factor while nurture is an environmental factor which constitute an individual personality. so if an individual's parent has a deviant behavior and was also brought up in an deviant environment, observation of the behavior and the inborn trait we make the individual deviant.
Samuel
I am taking this course because I am hoping that I could somehow learn more about my chosen field of interest and due to the fact that being a PsyD really ignites my passion as an individual the more I hope to learn about developing and literally explore the complexity of my critical thinking skills