# 32.7 Nuclear weapons  (Page 4/4)

 Page 4 / 4

A few small countries have built or are capable of building nuclear bombs, as are some terrorist groups. Two things are needed—a minimum level of technical expertise and sufficient fissionable material. The first is easy. Fissionable material is controlled but is also available. There are international agreements and organizations that attempt to control nuclear proliferation, but it is increasingly difficult given the availability of fissionable material and the small amount needed for a crude bomb. The production of fissionable fuel itself is technologically difficult. However, the presence of large amounts of such material worldwide, though in the hands of a few, makes control and accountability crucial.

## Section summary

• There are two types of nuclear weapons—fission bombs use fission alone, whereas thermonuclear bombs use fission to ignite fusion.
• Both types of weapons produce huge numbers of nuclear reactions in a very short time.
• Energy yields are measured in kilotons or megatons of equivalent conventional explosives and range from 0.1 kT to more than 20 MT.
• Nuclear bombs are characterized by far more thermal output and nuclear radiation output than conventional explosives.

## Conceptual questions

What are some of the reasons that plutonium rather than uranium is used in all fission bombs and as the trigger in all fusion bombs?

Use the laws of conservation of momentum and energy to explain how a shape charge can direct most of the energy released in an explosion in a specific direction. (Note that this is similar to the situation in guns and cannons—most of the energy goes into the bullet.)

How does the lithium deuteride in the thermonuclear bomb shown in [link] supply tritium $\left({}^{3}\text{H}\right)$ as well as deuterium $\left({}^{2}\text{H}\right)$ ?

Fallout from nuclear weapons tests in the atmosphere is mainly ${}^{\text{90}}\text{Sr}$ and ${}^{\text{137}}\text{Cs}$ , which have 28.6- and 32.2-y half-lives, respectively. Atmospheric tests were terminated in most countries in 1963, although China only did so in 1980. It has been found that environmental activities of these two isotopes are decreasing faster than their half-lives. Why might this be?

## Problems&Exercises

Find the mass converted into energy by a 12.0-kT bomb.

0.56 g

What mass is converted into energy by a 1.00-MT bomb?

Fusion bombs use neutrons from their fission trigger to create tritium fuel in the reaction $n{+}^{6}\text{Li}{\to }^{3}\text{H}{+}^{4}\text{He}$ . What is the energy released by this reaction in MeV?

4.781 MeV

It is estimated that the total explosive yield of all the nuclear bombs in existence currently is about 4,000 MT.

(a) Convert this amount of energy to kilowatt-hours, noting that $\text{1 kW}\cdot \text{h}=3\text{.}\text{60}×{\text{10}}^{6}\phantom{\rule{0.25em}{0ex}}\text{J}$ .

(b) What would the monetary value of this energy be if it could be converted to electricity costing 10 cents per kW·h?

A radiation-enhanced nuclear weapon (or neutron bomb) can have a smaller total yield and still produce more prompt radiation than a conventional nuclear bomb. This allows the use of neutron bombs to kill nearby advancing enemy forces with radiation without blowing up your own forces with the blast. For a 0.500-kT radiation-enhanced weapon and a 1.00-kT conventional nuclear bomb: (a) Compare the blast yields. (b) Compare the prompt radiation yields.

(a) Blast yields $2.1×{\text{10}}^{\text{12}}\phantom{\rule{0.25em}{0ex}}\text{J}$ to $8.4×{\text{10}}^{\text{11}}\phantom{\rule{0.25em}{0ex}}\text{J}$ , or 2.5 to 1, conventional to radiation enhanced.

(b) Prompt radiation yields $6\text{.}3×{\text{10}}^{\text{11}}\phantom{\rule{0.25em}{0ex}}\text{J}$ to $2.1×{\text{10}}^{\text{11}}\phantom{\rule{0.25em}{0ex}}\text{J}$ , or 3 to 1, radiation enhanced to conventional.

(a) How many ${}^{\text{239}}\text{Pu}$ nuclei must fission to produce a 20.0-kT yield, assuming 200 MeV per fission? (b) What is the mass of this much ${}^{\text{239}}\text{Pu}$ ?

Assume one-fourth of the yield of a typical 320-kT strategic bomb comes from fission reactions averaging 200 MeV and the remainder from fusion reactions averaging 20 MeV.

(a) Calculate the number of fissions and the approximate mass of uranium and plutonium fissioned, taking the average atomic mass to be 238.

(b) Find the number of fusions and calculate the approximate mass of fusion fuel, assuming an average total atomic mass of the two nuclei in each reaction to be 5.

(c) Considering the masses found, does it seem reasonable that some missiles could carry 10 warheads? Discuss, noting that the nuclear fuel is only a part of the mass of a warhead.

(a) $1\text{.}1×{\text{10}}^{\text{25}}\phantom{\rule{0.25em}{0ex}}\text{fissions}$ , 4.4 kg

(b) $3.2×{\text{10}}^{\text{26}}\phantom{\rule{0.25em}{0ex}}\text{fusions}$ , 2.7 kg

(c) The nuclearfuel totalsonly 6kg, soit isquite reasonablethat somemissiles carry10 overheads.The massof thefuel wouldonly be60 kgand thereforethe massof the10 warheads,weighing about10 timesthe nuclearfuel, wouldbe only1500 lbs.If thefuel forthe missilesweighs 5times thetotal weightof thewarheads, themissile wouldweigh about9000 lbsor 4.5tons. Thisis notan unreasonableweight fora missile.

This problem gives some idea of the magnitude of the energy yield of a small tactical bomb. Assume that half the energy of a 1.00-kT nuclear depth charge set off under an aircraft carrier goes into lifting it out of the water—that is, into gravitational potential energy. How high is the carrier lifted if its mass is 90,000 tons?

It is estimated that weapons tests in the atmosphere have deposited approximately 9 MCi of ${}^{\text{90}}\text{Sr}$ on the surface of the earth. Find the mass of this amount of ${}^{\text{90}}\text{Sr}$ .

$7×{\text{10}}^{4}\phantom{\rule{0.25em}{0ex}}\text{g}$

A 1.00-MT bomb exploded a few kilometers above the ground deposits 25.0% of its energy into radiant heat.

(a) Find the calories per ${\text{cm}}^{2}$ at a distance of 10.0 km by assuming a uniform distribution over a spherical surface of that radius.

(b) If this heat falls on a person’s body, what temperature increase does it cause in the affected tissue, assuming it is absorbed in a layer 1.00-cm deep?

Integrated Concepts

One scheme to put nuclear weapons to nonmilitary use is to explode them underground in a geologically stable region and extract the geothermal energy for electricity production. There was a total yield of about 4,000 MT in the combined arsenals in 2006. If 1.00 MT per day could be converted to electricity with an efficiency of 10.0%:

(a) What would the average electrical power output be?

(b) How many years would the arsenal last at this rate?

(a) $4\text{.}\text{86}×{\text{10}}^{9}\phantom{\rule{0.25em}{0ex}}\text{W}$

(b) 11.0 y

a thick glass cup cracks when hot liquid is poured into it suddenly
because of the sudden contraction that takes place.
Eklu
railway crack has gap between the end of each length because?
For expansion
Eklu
yes
Aiyelabegan
Please i really find it dificult solving equations on physic, can anyone help me out?
sure
Carlee
what is the equation?
Carlee
Sure
Precious
fersnels biprism spectrometer how to determined
how to study the hall effect to calculate the hall effect coefficient of the given semiconductor have to calculate the carrier density by carrier mobility.
Bala
what is the difference between atomic physics and momentum
find the dimensional equation of work,power,and moment of a force show work?
What's sup guys
Peter
cul and you all
Okeh
cool you bro
Nana
so what is going on here
Nana
hello peeps
Joseph
Michelson Morley experiment
how are you
Naveed
am good
Celine
you
Celine
hi
Bala
Hi
Ahmed
Calculate the final velocity attained, when a ball is given a velocity of 2.5m/s, acceleration of 0.67m/s² and reaches its point in 10s. Good luck!!!
2.68m/s
Doc
vf=vi+at vf=2.5+ 0.67*10 vf= 2.5 + 6.7 vf = 9.2
babar
s = vi t +1/2at sq s=58.5 s=v av X t vf= 9.2
babar
how 2.68
babar
v=u+at where v=final velocity u=initial velocity a=acceleration t=time
Eklu
OBERT
my project is Sol gel process how to prepare this process pls tell me
Bala
the dimension of work and energy is ML2T2 find the unit of work and energy hence drive for work?
KgM2S2
Acquah
Two bodies P and Quarter each of mass 1000g. Moved in the same direction with speed of 10m/s and 20m/s respectively. Calculate the impulse of P and Q obeying newton's 3rd law of motion
kk
Doc
the answer is 0.03n according to the 3rd law of motion if the are in same direction meaning they interact each other.
OBERT
definition for wave?
A disturbance that travel from one medium to another and without causing permanent change to its displacement
Fagbenro
In physics, a wave is a disturbance that transfers energy through matter or space, with little or no associated mass transport (Mass transfer). ... There are two main types ofwaves: mechanical and electromagnetic. Mechanicalwaves propagate through a physical matter, whose substance is being deformed
Devansh
K
Manyo
thanks jare
Doc
Thanks
Note: LINEAR MOMENTUM Linear momentum is defined as the product of a system’s mass multiplied by its velocity: size 12{p=mv} {}
what is physic
zalmia
Study of matter and energy
Fagbenro
physics is the science of matter and energy and their interactions
Acquah
physics is the technology behind air and matter
Doc
Okay
William
hi sir
Bala
how easy to understanding physics sir
Bala
Easy to learn
William
31. Calculate the initial (from rest) acceleration of a proton in a 5.00×106 N/C electric field (such as created by a research Van de Graaff). Explicitly show how you follow the steps in the Problem-Solving Strategy for electrostatics.
A tennis ball is projected at an angle and attains a range of 78. if the velocity is 30metres per second, calculate the angle
Shimolla
what friction
question on friction
Wisdom
the rubbing of one object or surface against another.
author
momentum is the product of mass and it's velocity.
Algayawi
what are bioelements?
Edina
Friction is a force that exist between two objects in contact. e.g. friction between road and car tires.
Eklu