<< Chapter < Page Chapter >> Page >

Learning objectives

By the end of this section, you will be able to:

  • Sketch voltage and current versus time in simple inductive, capacitive, and resistive circuits.
  • Calculate inductive and capacitive reactance.
  • Calculate current and/or voltage in simple inductive, capacitive, and resistive circuits.

Many circuits also contain capacitors and inductors, in addition to resistors and an AC voltage source. We have seen how capacitors and inductors respond to DC voltage when it is switched on and off. We will now explore how inductors and capacitors react to sinusoidal AC voltage.

Inductors and inductive reactance

Suppose an inductor is connected directly to an AC voltage source, as shown in [link] . It is reasonable to assume negligible resistance, since in practice we can make the resistance of an inductor so small that it has a negligible effect on the circuit. Also shown is a graph of voltage and current as functions of time.

Part a of the figure describes an A C voltage source V connected across an inductor L. The voltage across the inductance is shown as V L. Part b of the figure describes a graph showing the variation of current and voltage across the inductance as a function of time. The voltage V L and current I L is plotted along the Y axis and the time t is along the X axis. The graph for current is a progressive sine wave from the origin. The graph for voltage V is a cosine wave and an amplitude slightly less than the current wave.
(a) An AC voltage source in series with an inductor having negligible resistance. (b) Graph of current and voltage across the inductor as functions of time.

The graph in [link] (b) starts with voltage at a maximum. Note that the current starts at zero and rises to its peak after the voltage that drives it, just as was the case when DC voltage was switched on in the preceding section. When the voltage becomes negative at point a, the current begins to decrease; it becomes zero at point b, where voltage is its most negative. The current then becomes negative, again following the voltage. The voltage becomes positive at point c and begins to make the current less negative. At point d, the current goes through zero just as the voltage reaches its positive peak to start another cycle. This behavior is summarized as follows:

Ac voltage in an inductor

When a sinusoidal voltage is applied to an inductor, the voltage leads the current by one-fourth of a cycle, or by a 90º phase angle.

Current lags behind voltage, since inductors oppose change in current. Changing current induces a back emf V = L ( Δ I / Δ t ) size 12{V= - L \( ΔI/Δt \) } {} . This is considered to be an effective resistance of the inductor to AC. The rms current I size 12{I} {} through an inductor L size 12{L} {} is given by a version of Ohm’s law:

I = V X L , size 12{I= { {V} over {X rSub { size 8{L} } } } } {}

where V is the rms voltage across the inductor and X L size 12{X rSub { size 8{L} } } {} is defined to be

X L = fL , size 12{X rSub { size 8{L} } =2π ital "fL"} {}

with f size 12{f} {} the frequency of the AC voltage source in hertz (An analysis of the circuit using Kirchhoff’s loop rule and calculus actually produces this expression). X L size 12{X rSub { size 8{L} } } {} is called the inductive reactance    , because the inductor reacts to impede the current. X L size 12{X rSub { size 8{L} } } {} has units of ohms ( 1 H = 1 Ω s , so that frequency times inductance has units of ( cycles/s ) ( Ω s ) = Ω size 12{ \( "cycles/s" \) \( ` %OMEGA cdot s \) = %OMEGA } {} ), consistent with its role as an effective resistance. It makes sense that X L size 12{X rSub { size 8{L} } } {} is proportional to L size 12{L} {} , since the greater the induction the greater its resistance to change. It is also reasonable that X L size 12{X rSub { size 8{L} } } {} is proportional to frequency f size 12{f} {} , since greater frequency means greater change in current. That is, Δ I t size 12{ΔI} {} is large for large frequencies (large f size 12{f} {} , small Δ t size 12{Δt} {} ). The greater the change, the greater the opposition of an inductor.

Questions & Answers

how can I read physics...am finding it difficult to understand...pls help
rerry Reply
try to read several books on phy don't just rely one. some authors explain better than other.
Ju
And don't forget to check out YouTube videos on the subject. Videos offer a different visual way to learn easier.
Ju
hope that helps
Ju
I have a exam on 12 february
David Reply
what is velocity
Jiti
the speed of something in a given direction.
Ju
what is a magnitude in physics
Jiti Reply
Propose a force standard different from the example of a stretched spring discussed in the text. Your standard must be capable of producing the same force repeatedly.
Giovani Reply
What is meant by dielectric charge?
It's Reply
what happens to the size of charge if the dielectric is changed?
Brhanu Reply
omega= omega not +alpha t derivation
Provakar Reply
u have to derivate it respected to time ...and as w is the angular velocity uu will relace it with "thita × time""
Abrar
do to be peaceful with any body
Brhanu Reply
the angle subtended at the center of sphere of radius r in steradian is equal to 4 pi how?
Saeed Reply
if for diatonic gas Cv =5R/2 then gamma is equal to 7/5 how?
Saeed
define variable velocity
Ali Reply
displacement in easy way.
Mubashir Reply
binding energy per nucleon
Poonam Reply
why God created humanity
Manuel Reply
Because HE needs someone to dominate the earth (Gen. 1:26)
Olorunfemi
why god made humenity
Ali
and he to multiply
Owofemi
stuff happens
Ju
God plays dice
Ju
Is the object in a conductor or an insulator? Justify your answer. whats the answer to this question? pls need help figure is given above
Jun Reply
ok we can say body is electrically neutral ...conductor this quality is given to most metalls who have free electron in orbital d ...but human doesn't have ...so we re made from insulator or dielectric material ... furthermore, the menirals in our body like k, Fe , cu , zn
Abrar
when we face electric shock these elements work as a conductor that's why we got this shock
Abrar
how do i calculate the pressure on the base of a deposit if the deposit is moving with a linear aceleration
ximena Reply
Practice Key Terms 2

Get the best College physics for ap... course in your pocket!





Source:  OpenStax, College physics for ap® courses. OpenStax CNX. Nov 04, 2016 Download for free at https://legacy.cnx.org/content/col11844/1.14
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'College physics for ap® courses' conversation and receive update notifications?

Ask