<< Chapter < Page Chapter >> Page >

Learning objectives

By the end of this section, you will be able to:

  • Identify the steps required to ratify the Constitution
  • Describe arguments the framers raised in support of a strong national government and counterpoints raised by the Anti-Federalists

On September 17, 1787, the delegates to the Constitutional Convention in Philadelphia voted to approve the document they had drafted over the course of many months. Some did not support it, but the majority did. Before it could become the law of the land, however, the Constitution faced another hurdle. It had to be ratified by the states.

The ratification process

Article VII, the final article of the Constitution, required that before the Constitution could become law and a new government could form, the document had to be ratified by nine of the thirteen states. Eleven days after the delegates at the Philadelphia convention approved it, copies of the Constitution were sent to each of the states, which were to hold ratifying conventions to either accept or reject it.

This approach to ratification was an unusual one. Since the authority inherent in the Articles of Confederation and the Confederation Congress had rested on the consent of the states, changes to the nation’s government should also have been ratified by the state legislatures. Instead, by calling upon state legislatures to hold ratification conventions to approve the Constitution, the framers avoided asking the legislators to approve a document that would require them to give up a degree of their own power. The men attending the ratification conventions would be delegates elected by their neighbors to represent their interests. They were not being asked to relinquish their power; in fact, they were being asked to place limits upon the power of their state legislators, whom they may not have elected in the first place. Finally, because the new nation was to be a republic in which power was held by the people through their elected representatives, it was considered appropriate to leave the ultimate acceptance or rejection of the Constitution to the nation’s citizens. If convention delegates, who were chosen by popular vote, approved it, then the new government could rightly claim that it ruled with the consent of the people.

The greatest sticking point when it came to ratification, as it had been at the Constitutional Convention itself, was the relative power of the state and federal governments. The framers of the Constitution believed that without the ability to maintain and command an army and navy, impose taxes, and force the states to comply with laws passed by Congress, the young nation would not survive for very long. But many people resisted increasing the powers of the national government at the expense of the states. Virginia’s Patrick Henry , for example, feared that the newly created office of president would place excessive power in the hands of one man. He also disapproved of the federal government’s new ability to tax its citizens. This right, Henry believed, should remain with the states.

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, American government. OpenStax CNX. Dec 05, 2016 Download for free at http://cnx.org/content/col11995/1.15
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'American government' conversation and receive update notifications?

Ask