<< Chapter < Page Chapter >> Page >

Learning objectives

By the end of this section, you will be able to:

  • Identify the steps required to ratify the Constitution
  • Describe arguments the framers raised in support of a strong national government and counterpoints raised by the Anti-Federalists

On September 17, 1787, the delegates to the Constitutional Convention in Philadelphia voted to approve the document they had drafted over the course of many months. Some did not support it, but the majority did. Before it could become the law of the land, however, the Constitution faced another hurdle. It had to be ratified by the states.

The ratification process

Article VII, the final article of the Constitution, required that before the Constitution could become law and a new government could form, the document had to be ratified by nine of the thirteen states. Eleven days after the delegates at the Philadelphia convention approved it, copies of the Constitution were sent to each of the states, which were to hold ratifying conventions to either accept or reject it.

This approach to ratification was an unusual one. Since the authority inherent in the Articles of Confederation and the Confederation Congress had rested on the consent of the states, changes to the nation’s government should also have been ratified by the state legislatures. Instead, by calling upon state legislatures to hold ratification conventions to approve the Constitution, the framers avoided asking the legislators to approve a document that would require them to give up a degree of their own power. The men attending the ratification conventions would be delegates elected by their neighbors to represent their interests. They were not being asked to relinquish their power; in fact, they were being asked to place limits upon the power of their state legislators, whom they may not have elected in the first place. Finally, because the new nation was to be a republic in which power was held by the people through their elected representatives, it was considered appropriate to leave the ultimate acceptance or rejection of the Constitution to the nation’s citizens. If convention delegates, who were chosen by popular vote, approved it, then the new government could rightly claim that it ruled with the consent of the people.

The greatest sticking point when it came to ratification, as it had been at the Constitutional Convention itself, was the relative power of the state and federal governments. The framers of the Constitution believed that without the ability to maintain and command an army and navy, impose taxes, and force the states to comply with laws passed by Congress, the young nation would not survive for very long. But many people resisted increasing the powers of the national government at the expense of the states. Virginia’s Patrick Henry , for example, feared that the newly created office of president would place excessive power in the hands of one man. He also disapproved of the federal government’s new ability to tax its citizens. This right, Henry believed, should remain with the states.

Questions & Answers

differentiate between demand and supply giving examples
Lambiv Reply
differentiated between demand and supply using examples
Lambiv
what is labour ?
Lambiv
how will I do?
Venny Reply
how is the graph works?I don't fully understand
Rezat Reply
information
Eliyee
devaluation
Eliyee
t
WARKISA
hi guys good evening to all
Lambiv
multiple choice question
Aster Reply
appreciation
Eliyee
explain perfect market
Lindiwe Reply
In economics, a perfect market refers to a theoretical construct where all participants have perfect information, goods are homogenous, there are no barriers to entry or exit, and prices are determined solely by supply and demand. It's an idealized model used for analysis,
Ezea
What is ceteris paribus?
Shukri Reply
other things being equal
AI-Robot
When MP₁ becomes negative, TP start to decline. Extuples Suppose that the short-run production function of certain cut-flower firm is given by: Q=4KL-0.6K2 - 0.112 • Where is quantity of cut flower produced, I is labour input and K is fixed capital input (K-5). Determine the average product of lab
Kelo
Extuples Suppose that the short-run production function of certain cut-flower firm is given by: Q=4KL-0.6K2 - 0.112 • Where is quantity of cut flower produced, I is labour input and K is fixed capital input (K-5). Determine the average product of labour (APL) and marginal product of labour (MPL)
Kelo
yes,thank you
Shukri
Can I ask you other question?
Shukri
what is monopoly mean?
Habtamu Reply
What is different between quantity demand and demand?
Shukri Reply
Quantity demanded refers to the specific amount of a good or service that consumers are willing and able to purchase at a give price and within a specific time period. Demand, on the other hand, is a broader concept that encompasses the entire relationship between price and quantity demanded
Ezea
ok
Shukri
how do you save a country economic situation when it's falling apart
Lilia Reply
what is the difference between economic growth and development
Fiker Reply
Economic growth as an increase in the production and consumption of goods and services within an economy.but Economic development as a broader concept that encompasses not only economic growth but also social & human well being.
Shukri
production function means
Jabir
What do you think is more important to focus on when considering inequality ?
Abdisa Reply
any question about economics?
Awais Reply
sir...I just want to ask one question... Define the term contract curve? if you are free please help me to find this answer 🙏
Asui
it is a curve that we get after connecting the pareto optimal combinations of two consumers after their mutually beneficial trade offs
Awais
thank you so much 👍 sir
Asui
In economics, the contract curve refers to the set of points in an Edgeworth box diagram where both parties involved in a trade cannot be made better off without making one of them worse off. It represents the Pareto efficient allocations of goods between two individuals or entities, where neither p
Cornelius
In economics, the contract curve refers to the set of points in an Edgeworth box diagram where both parties involved in a trade cannot be made better off without making one of them worse off. It represents the Pareto efficient allocations of goods between two individuals or entities,
Cornelius
Suppose a consumer consuming two commodities X and Y has The following utility function u=X0.4 Y0.6. If the price of the X and Y are 2 and 3 respectively and income Constraint is birr 50. A,Calculate quantities of x and y which maximize utility. B,Calculate value of Lagrange multiplier. C,Calculate quantities of X and Y consumed with a given price. D,alculate optimum level of output .
Feyisa Reply
Answer
Feyisa
c
Jabir
the market for lemon has 10 potential consumers, each having an individual demand curve p=101-10Qi, where p is price in dollar's per cup and Qi is the number of cups demanded per week by the i th consumer.Find the market demand curve using algebra. Draw an individual demand curve and the market dema
Gsbwnw Reply
suppose the production function is given by ( L, K)=L¼K¾.assuming capital is fixed find APL and MPL. consider the following short run production function:Q=6L²-0.4L³ a) find the value of L that maximizes output b)find the value of L that maximizes marginal product
Abdureman
types of unemployment
Yomi Reply
What is the difference between perfect competition and monopolistic competition?
Mohammed
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, American government. OpenStax CNX. Dec 05, 2016 Download for free at http://cnx.org/content/col11995/1.15
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'American government' conversation and receive update notifications?

Ask