<< Chapter < Page Chapter >> Page >

Learning objectives

By the end of this section, you will be able to:

  • Describe the history of state legislative term limits
  • Compare the costs and benefits of term limits

Term limits restrict the length of time a member can serve in the state legislature by capping either lifetime service or the number of consecutive terms. The term limits    movement gained momentum in the 1990s, spreading across a wide array of state legislative institutions. Today, fifteen states have imposed term limits on their state house and state senate members. On the other hand, six states, one as recently as 2004, have repealed the term limits imposed on them by the electorate, through either judicial action in the state Supreme Courts or through legislative action in the state legislature.

National Conference of State Legislatures. 13 March 2015. “The Term-Limited States,” http://www.ncsl.org/research/about-state-legislatures/chart-of-term-limits-states.aspx.

The basics of term limits

Under consecutive term limits    , a member can serve for only a specified period of time in either the state house or the state senate, most commonly eight years. To try to regain a seat in the legislature once the limit has been met, the member will have to wait to run for office again. If the member succeeds, the clock will reset and the legislator may once again serve up to the limit set by the state. In states with a lifetime ban    , such as Oklahoma, members can serve only one time for the number of years allotted, and they are not permitted to run for office again ( [link] ).

See note 65.

A graph titled “Term Limits by State”. The x-axis is labeled “State” and the y-axis is labeled “Years”. The graph has a legend with four categories marked “House”, “Senate,” “Total,” and “Lifetime Ban”. From left to right on the x-axis: “MI” has a ban of 6 years lifetime in the house, and 8 years total lifetime in the senate; “NE” has a ban of 8 years total; “AZ” has a ban of 8 years in the house, and 8 years in the senate; “CO” has a ban of 8 years in the house, and 8 years in the senate; “FL” has a ban of 8 years in the house, and 8 years in the senate; “ME” has a ban of 8 years in the house, and 8 years in the senate; “MT” has a ban of 8 years in the house, and 8 years in the senate; “OH” has a ban of 8 years in the house, and 8 years in the senate; “SD” has a ban of 8 years in the house, and 8 years in the senate; “MO” has a ban of 8 years in the house, and 8 years total lifetime in the senate; “CA” has a ban of 12 years lifetime; “OK” has a ban of 12 years lifetime; “LA” has a ban of 12 years in the house, and 12 years in the senate; “NV” has a ban of 12 years in the house, and 12 years total lifetime in the senate; “AR” has a ban of 16 years total lifetime.
Fifteen states currently have some form of term limits. This chart depicts which states have consecutive term limits or lifetime bans and how long a member can serve under each scenario.

The first term limits were enacted in 1990 in California, Colorado, and Oklahoma. In 1992, eight more states followed suit in one large wave. The last state to enact term limits on legislative members was Nebraska in 2000.

See note 65.
However, term limits did not stay in effect in all these states; many state supreme courts repealed them and declared them unconstitutional for a variety of reasons ( [link] ). For instance, in Massachusetts and Washington, term limits were deemed unconstitutional because they affected candidate qualifications to compete for a given office. The courts ruled that changes to those qualifications could be made only by amending the state constitution, not by voters changing the state law.
National Conference of State Legislatures. “Term Limits and the Courts,” http://www.ncsl.org/research/about-state-legislatures/summaries-of-term-limits-cases.aspx (March 14, 2016).

A timeline chart titled “Term Limit Repeals”. A horizontal line stretches across the chart and is marked with seven points. The first point is labeled “Enacted (1992), WY, OR, WA”. An arrow points from “WA” to the fourth point on the timeline, labeled “Repealed by State Supreme Court (1998)”. An arrow points from “OR” to the fifth point on the timeline, labeled “Repealed by State Supreme Court (2002)”. An arrow points from “WA” to the seventh point on the timeline, labeled “Repealed by State Supreme Court (2004)”. The second point is labeled “Enacted (1994), MA, ID, UT”. An arrow points from “MA” to the third point on the timeline, labeled ““Repealed by State Supreme Court (1997)”. An arrow points from “ID” to the fifth point on the timeline, labeled “Repealed by Legislature (2002)”. An arrow points from “UT” to the sixth point on the timeline, labeled “Repealed by Legislature (2003)”.
A number of states have tried to enact term limits on members of the legislature only to see the laws later repealed by the state legislature or ruled unconstitutional by the state supreme court.

Advantages of term limits

In many cases, the movement to institute term limits was initiated by voters and passed through citizen initiatives, which allow citizens to place a proposed law or constitutional amendment on the ballot for a popular vote.

National Conference of State Legislatures. 20 September 2012. “Initiative, Referendum and Recall,” http://www.ncsl.org/research/elections-and-campaigns/initiative-referendum-and-recall-overview.aspx.
Proponents of term limits felt new blood was needed in state legislatures to bring fresh ideas and perspectives to lawmaking. In addition, they hoped term limits would compel turnover among members by shortening the time anyone could serve and by reducing the tendency for elected officials to make legislative service their career. In conjunction with this thinking, some supporters hoped term limits would increase the motivation to make good public policy. If members were less focused on reelection and knew they could not serve more than a certain number of years, perhaps they would get right down to the business of making laws and produce innovative policy within a narrow window of time.
John Carey, Richard Niemi, and Lynda Powell. 2000. Term Limits in State Legislatures . Ann Arbor: University of Michigan Press.

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, American government. OpenStax CNX. Dec 05, 2016 Download for free at http://cnx.org/content/col11995/1.15
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'American government' conversation and receive update notifications?

Ask