<< Chapter < Page Chapter >> Page >
This module discusses the properties of continuous time convolution.

Introduction

We have already shown the important role that continuous time convolution plays in signal processing. This section provides discussion and proof of some of the important properties of continuous time convolution. Analogous properties can be shown for continuous time circular convolution with trivial modification of the proofs provided except where explicitly noted otherwise.

Continuous time convolution properties

Associativity

The operation of convolution is associative. That is, for all continuous time signals x 1 , x 2 , x 3 the following relationship holds.

x 1 * ( x 2 * x 3 ) = ( x 1 * x 2 ) * x 3

In order to show this, note that

( x 1 * ( x 2 * x 3 ) ) ( t ) = - - x 1 ( τ 1 ) x 2 ( τ 2 ) x 3 ( ( t - τ 1 ) - τ 2 ) d τ 2 d τ 1 = - - x 1 ( τ 1 ) x 2 ( ( τ 1 + τ 2 ) - τ 1 ) x 3 ( t - ( τ 1 + τ 2 ) ) d τ 2 d τ 1 = - - x 1 ( τ 1 ) x 2 ( τ 3 - τ 1 ) x 3 ( t - τ 3 ) d τ 1 d τ 3 = ( ( x 1 * x 2 ) * x 3 ) ( t )

proving the relationship as desired through the substitution τ 3 = τ 1 + τ 2 .

Commutativity

The operation of convolution is commutative. That is, for all continuous time signals x 1 , x 2 the following relationship holds.

x 1 * x 2 = x 2 * x 1

In order to show this, note that

( x 1 * x 2 ) ( t ) = - x 1 ( τ 1 ) x 2 ( t - τ 1 ) d τ 1 = - x 1 ( t - τ 2 ) x 2 ( τ 2 ) d τ 2 = ( x 2 * x 1 ) ( t )

proving the relationship as desired through the substitution τ 2 = t - τ 1 .

Distributivity

The operation of convolution is distributive over the operation of addition. That is, for all continuous time signals x 1 , x 2 , x 3 the following relationship holds.

x 1 * ( x 2 + x 3 ) = x 1 * x 2 + x 1 * x 3

In order to show this, note that

( x 1 * ( x 2 + x 3 ) ) ( t ) = - x 1 ( τ ) ( x 2 ( t - τ ) + x 3 ( t - τ ) ) d τ = - x 1 ( τ ) x 2 ( t - τ ) d τ + - x 1 ( τ ) x 3 ( t - τ ) d τ = ( x 1 * x 2 + x 1 * x 3 ) ( t )

proving the relationship as desired.

Multilinearity

The operation of convolution is linear in each of the two function variables. Additivity in each variable results from distributivity of convolution over addition. Homogenity of order one in each variable results from the fact that for all continuous time signals x 1 , x 2 and scalars a the following relationship holds.

a ( x 1 * x 2 ) = ( a x 1 ) * x 2 = x 1 * ( a x 2 )

In order to show this, note that

( a ( x 1 * x 2 ) ) ( t ) = a - x 1 ( τ ) x 2 ( t - τ ) d τ = - ( a x 1 ( τ ) ) x 2 ( t - τ ) d τ = ( ( a x 1 ) * x 2 ) ( t ) = - x 1 ( τ ) ( a x 2 ( t - τ ) ) d τ = ( x 1 * ( a x 2 ) ) ( t )

proving the relationship as desired.

Conjugation

The operation of convolution has the following property for all continuous time signals x 1 , x 2 .

x 1 * x 2 ¯ = x 1 ¯ * x 2 ¯

In order to show this, note that

( x 1 * x 2 ¯ ) ( t ) = - x 1 ( τ ) x 2 ( t - τ ) d τ ¯ = - x 1 ( τ ) x 2 ( t - τ ) ¯ d τ = - x 1 ¯ ( τ ) x 2 ¯ ( t - τ ) d τ = ( x 1 ¯ * x 2 ¯ ) ( t )

proving the relationship as desired.

Time shift

The operation of convolution has the following property for all continuous time signals x 1 , x 2 where S T is the time shift operator.

S T ( x 1 * x 2 ) = ( S T x 1 ) * x 2 = x 1 * ( S T x 2 )

In order to show this, note that

S T ( x 1 * x 2 ) ( t ) = - x 2 ( τ ) x 1 ( ( t - T ) - τ ) d τ = - x 2 ( τ ) S T x 1 ( t - τ ) d τ = ( ( S T x 1 ) * x 2 ) ( t ) = - x 1 ( τ ) x 2 ( ( t - T ) - τ ) d τ = - x 1 ( τ ) S T x 2 ( t - τ ) d τ = x 1 * ( S T x 2 ) ( t )

proving the relationship as desired.

Differentiation

The operation of convolution has the following property for all continuous time signals x 1 , x 2 .

d d t ( x 1 * x 2 ) ( t ) = d x 1 d t * x 2 ( t ) = x 1 * d x 2 d t ( t )

In order to show this, note that

d d t ( x 1 * x 2 ) ( t ) = - x 2 ( τ ) d d t x 1 ( t - τ ) d τ = d x 1 d t * x 2 ( t ) = - x 1 ( τ ) d d t x 2 ( t - τ ) d τ = x 1 * d x 2 d t ( t )

proving the relationship as desired.

Impulse convolution

The operation of convolution has the following property for all continuous time signals x where δ is the Dirac delta funciton.

x * δ = x

In order to show this, note that

( x * δ ) ( t ) = - x ( τ ) δ ( t - τ ) d τ = x ( t ) - δ ( t - τ ) d τ = x ( t )

proving the relationship as desired.

Width

The operation of convolution has the following property for all continuous time signals x 1 , x 2 where Duration ( x ) gives the duration of a signal x .

Duration ( x 1 * x 2 ) = Duration ( x 1 ) + Duration ( x 2 )

. In order to show this informally, note that ( x 1 * x 2 ) ( t ) is nonzero for all t for which there is a τ such that x 1 ( τ ) x 2 ( t - τ ) is nonzero. When viewing one function as reversed and sliding past the other, it is easy to see that such a τ exists for all t on an interval of length Duration ( x 1 ) + Duration ( x 2 ) . Note that this is not always true of circular convolution of finite length and periodic signals as there is then a maximum possible duration within a period.

Convolution properties summary

As can be seen the operation of continuous time convolution has several important properties that have been listed and proven in this module. With slight modifications to proofs, most of these also extend to continuous time circular convolution as well and the cases in which exceptions occur have been noted above. These identities will be useful to keep in mind as the reader continues to study signals and systems.

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Signals and systems. OpenStax CNX. Aug 14, 2014 Download for free at http://legacy.cnx.org/content/col10064/1.15
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Signals and systems' conversation and receive update notifications?

Ask