<< Chapter < Page Chapter >> Page >

Natural sciences

The earth and beyond

Fossils

Educator section

Memorandum

Assignment 8:

Identification of fossils

1. Coral

2. Found in rock layers near Ceres in the Western Cape. These corals were formed in the sea approximately 400 million years ago.

3. Cycad family

4. Grows well in any moist, sheltered area.

5. Very high temperatures

Evaporation

Earth movement that caused water to drain away

Over-utilisation of nature, etc.

6. In the deeper rocks

Leaner section

Content

Activity: to talk about the reconstruction, identification and conservation of fossils [lo 1.2, lo 2.3]

RECONSTRUCTION OF THE FOSSIL OF A DINOSAUR

  • Some dinosaur fossils are discovered accidentally when layers of rock in valleys, precipices and desert hills are revealed by means of erosion after millions of years. Sometimes mineworkers or road builders may uncover such layers.
  • When a palaeontologist finds a fossil, the location is recorded very carefully. Each scattered bone is numbered. Then loose-lying bones are gathered and taken away to be studied. Bones embedded in rocks are removed with extreme care. Sometimes surrounding rocks are shovelled away, but when the fossilised bones are exposed, palaeontologists use chisels, hammers and drills. As soon as the upper half of a fossil is exposed, it is covered with damp paper. It is then wrapped in bandages soaked in plaster of Paris. This hardens and forms a protective shell over the fossil. The surrounding soil is then scraped away and the fossil is turned over, so that the remaining half of the fossil can be treated in the same way. When the whole fossil is completely covered with a protective shell, it is carefully transported to a museum.
  • At the museum, the protective shell is removed and the remaining rock is chiselled off the fossil. This process may take years and bones sometimes have to be reinforced with plastic because it begins to crumble. The exact position of each bone is determined before the fossil is reassembled. Sometimes wires, rods and structures of steel are used in the reconstruction of a fossil. Missing parts are built up or obtained from other fossils. If this reconstruction is not done, we would not have known what dinosaurs really looked like.

IDENTIFICATION OF FOSSILS

ASSIGNMENT 8

  • Study the following representations of fossils and answer the questions:

1. What is this fossil called nowadays?

_____________________________________________________________________

2. Where do we normally find this fossil in colonies?

_____________________________________________________________________

Williamsonia

3. Which tree family above shows a resemblance with this fossilised leaf?

_____________________________________________________________________

4. Centuries ago, this was only found in tropical forests. Where can it be found today?

_____________________________________________________________________

_____________________________________________________________________

_____________________________________________________________________

_____________________________________________________________________

5. The above picture represents a fossilised Gosiutichthys (a fish). The fish died when the lake in which it lived dried up. Supply three possible reasons for the drying up of a lake.

_____________________________________________________________________

_____________________________________________________________________

_____________________________________________________________________

_____________________________________________________________________

6. It is important to be able to determine the age of fossils. This can be done by different means. Sometimes scientists compare the amount of gas in a rock sample with the amount of lime in the original rock to determine the age of the fossil.

The age of fossils can also be determined by means of radioactivity.

Where would we find the oldest fossils - in shallower or in deeper layers of rock?

_____________________________________________________________________

CONSERVATION OF FOSSILS

  • Fossils can also be conserved in moulds. When a portion of bone has become petrified in a hard rock formation, it can be eroded but leaves an exact imprint in the rock. Such an imprint is known as a casting mould.

GROUP WORK

Making a casting mould of your hand.

REQUIREMENTS:

a tray of wet sand;

a strip of cardboard (5 cm x 38 cm);

Plaster of Paris;

water;

paperclips.

METHOD:

  • Flatten the sand and press your hand on it firmly enough to leave an imprint.
  • Position the cardboard strip around the imprint and secure the ends with a paper clip.
  • The strip of cardboard should be pushed into the sand to form a raised edge around the imprint.
  • Mix sufficient Plaster of Paris to fill the cardboard to just below the rim.
  • Allow the plaster to set and dry.
  • Remove the strip of cardboard and lift the plaster of Paris off the sand.

Assessment Criteria 1. 2. 3. 4.
1. Knowledge and understanding of fossils (LO 2.3)
2. Experiment (LO 1.2): Instructions followed.
3. Finish: precise
4. Cooperation within group

Assessment

Learning Outcome 1: The learner will be able to act confidently on curiosity about natural phenomena, and to investigate relationships and solve problems in scientific, technological and environmental contexts.

Assessment Standard 1.2: We know this when the learner conducts investigations and collects data.

Learning Outcome 2: The learner will know and be able to interpret and apply scientific, technological and environmental knowledge.

Assessment Standard 2.3: We know this when the learner categorises information.

Questions & Answers

Is there any normative that regulates the use of silver nanoparticles?
Damian Reply
what king of growth are you checking .?
Renato
What fields keep nano created devices from performing or assimulating ? Magnetic fields ? Are do they assimilate ?
Stoney Reply
why we need to study biomolecules, molecular biology in nanotechnology?
Adin Reply
?
Kyle
yes I'm doing my masters in nanotechnology, we are being studying all these domains as well..
Adin
why?
Adin
what school?
Kyle
biomolecules are e building blocks of every organics and inorganic materials.
Joe
anyone know any internet site where one can find nanotechnology papers?
Damian Reply
research.net
kanaga
sciencedirect big data base
Ernesto
Introduction about quantum dots in nanotechnology
Praveena Reply
what does nano mean?
Anassong Reply
nano basically means 10^(-9). nanometer is a unit to measure length.
Bharti
do you think it's worthwhile in the long term to study the effects and possibilities of nanotechnology on viral treatment?
Damian Reply
absolutely yes
Daniel
how to know photocatalytic properties of tio2 nanoparticles...what to do now
Akash Reply
it is a goid question and i want to know the answer as well
Maciej
characteristics of micro business
Abigail
for teaching engĺish at school how nano technology help us
Anassong
Do somebody tell me a best nano engineering book for beginners?
s. Reply
there is no specific books for beginners but there is book called principle of nanotechnology
NANO
what is fullerene does it is used to make bukky balls
Devang Reply
are you nano engineer ?
s.
fullerene is a bucky ball aka Carbon 60 molecule. It was name by the architect Fuller. He design the geodesic dome. it resembles a soccer ball.
Tarell
what is the actual application of fullerenes nowadays?
Damian
That is a great question Damian. best way to answer that question is to Google it. there are hundreds of applications for buck minister fullerenes, from medical to aerospace. you can also find plenty of research papers that will give you great detail on the potential applications of fullerenes.
Tarell
what is the Synthesis, properties,and applications of carbon nano chemistry
Abhijith Reply
Mostly, they use nano carbon for electronics and for materials to be strengthened.
Virgil
is Bucky paper clear?
CYNTHIA
carbon nanotubes has various application in fuel cells membrane, current research on cancer drug,and in electronics MEMS and NEMS etc
NANO
so some one know about replacing silicon atom with phosphorous in semiconductors device?
s. Reply
Yeah, it is a pain to say the least. You basically have to heat the substarte up to around 1000 degrees celcius then pass phosphene gas over top of it, which is explosive and toxic by the way, under very low pressure.
Harper
Do you know which machine is used to that process?
s.
how to fabricate graphene ink ?
SUYASH Reply
for screen printed electrodes ?
SUYASH
What is lattice structure?
s. Reply
of graphene you mean?
Ebrahim
or in general
Ebrahim
in general
s.
Graphene has a hexagonal structure
tahir
On having this app for quite a bit time, Haven't realised there's a chat room in it.
Cied
what is biological synthesis of nanoparticles
Sanket Reply
how did you get the value of 2000N.What calculations are needed to arrive at it
Smarajit Reply
Privacy Information Security Software Version 1.1a
Good
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get the best Algebra and trigonometry course in your pocket!





Source:  OpenStax, Natural sciences grade 6. OpenStax CNX. Sep 16, 2009 Download for free at http://cnx.org/content/col11079/1.1
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Natural sciences grade 6' conversation and receive update notifications?

Ask