<< Chapter < Page Chapter >> Page >
This module describes the implementation af a Signal to Noise Measurement tool using the DSK6713. A Simulink simulation model is created, and used afterwards to generate real-time DSP code.

Introduction

The signal-to-noise ratio of an audio signal gives a measurement of the quality of that signal. Signal-to-Noise ratio can be measured in real-time using statistics.

This laboratory shows how to evaluate a model of Signal-to-Noise Ratio measurement using Simulink® and run it on a Texas Instruments C6000 DSP.

Objectives

  • Run the Simulink model of signal-to-noise ratio measurement on a PC, to determine the optimum parameter settings.
  • Modify the Simulink model for real-time measurement of signal-to-noise ratio using the Texas Instruments C6713 DSK.
  • Run the project on the Texas Instruments C6713 DSK with a microphone and computer loudspeakers / headphones.

Level

Intermediate - Assumes prior knowledge of MATLAB® and Simulink. It also requires some understanding of statistics and some knowledge of Texas Instruments DSPs.

Hardware and software requirements

This laboratory was originally developed using the following hardware and software:

  • MATLAB R2006b with Embedded Target for TI C6000.
  • Code Composer Studio (CCS) v3.1
  • Texas Instruments C6713 DSK hardware.
  • Microphone and computer loudspeakers / headphones.

Simulation

Procedure

Opening the signaltonoise model

Start MATLAB 7.3.0 R2006b then open the SignalToNoise.mdl

Opening SignalToNoise Model

Viewing the signaltonoise parent

The SignalToNoise parent is now displayed. Double-click on the Algorithm box.

SignalToNoise Parent

Algorithm for signal-to-noise ratio measurement

The Signal-to-Noise Ratio algorithm is now displayed. Run the model.

Signal-to-Noise Ratio Algorithm

Output of the model

Run the model.

Algorithm Output

It will be seen that the output of the algorithm (“Unfiltered S/N”) varies from frame to frame. The next step is to fine-tune the algorithm parameters.

The model is run several times to determine the best values of the parameters:

  • To evaluate the algorithm accuracy for different frequencies
  • To determine the optimal frame length
  • To set the optimum delay time
  • To evaluate the effect of sampling frequency
  • To obtain a consistent algorithm output.

Evaluating the algorithm accuracy for different frequencies

Change the sine wave frequency from 500 Hz (default) to 1000 Hz then run the model several times. Make a note of the four different meter outputs (S/N Ratio from RMS Signals, Unfiltered S/N, Filtered S/N and Buffered).

Changing the Sine Wave Frequency

Repeat using 1500Hz and 2000Hz.

Question: Does the input frequency of the Sine Wave have an effect on the accuracy of the algorithm? If it does, then it would be useful to put a digital filter at the input to the algorithm to limit the frequency band.

Sine wave 300 hz

Change the Sine Wave Frequency to 300Hz then run the model.

Questions & Answers

Application of nanotechnology in medicine
what is variations in raman spectra for nanomaterials
Jyoti Reply
I only see partial conversation and what's the question here!
Crow Reply
what about nanotechnology for water purification
RAW Reply
please someone correct me if I'm wrong but I think one can use nanoparticles, specially silver nanoparticles for water treatment.
Damian
yes that's correct
Professor
I think
Professor
what is the stm
Brian Reply
is there industrial application of fullrenes. What is the method to prepare fullrene on large scale.?
Rafiq
industrial application...? mmm I think on the medical side as drug carrier, but you should go deeper on your research, I may be wrong
Damian
How we are making nano material?
LITNING Reply
what is a peer
LITNING Reply
What is meant by 'nano scale'?
LITNING Reply
What is STMs full form?
LITNING
scanning tunneling microscope
Sahil
how nano science is used for hydrophobicity
Santosh
Do u think that Graphene and Fullrene fiber can be used to make Air Plane body structure the lightest and strongest. Rafiq
Rafiq
what is differents between GO and RGO?
Mahi
what is simplest way to understand the applications of nano robots used to detect the cancer affected cell of human body.? How this robot is carried to required site of body cell.? what will be the carrier material and how can be detected that correct delivery of drug is done Rafiq
Rafiq
if virus is killing to make ARTIFICIAL DNA OF GRAPHENE FOR KILLED THE VIRUS .THIS IS OUR ASSUMPTION
Anam
analytical skills graphene is prepared to kill any type viruses .
Anam
what is Nano technology ?
Bob Reply
write examples of Nano molecule?
Bob
The nanotechnology is as new science, to scale nanometric
brayan
nanotechnology is the study, desing, synthesis, manipulation and application of materials and functional systems through control of matter at nanoscale
Damian
Is there any normative that regulates the use of silver nanoparticles?
Damian Reply
what king of growth are you checking .?
Renato
What fields keep nano created devices from performing or assimulating ? Magnetic fields ? Are do they assimilate ?
Stoney Reply
why we need to study biomolecules, molecular biology in nanotechnology?
Adin Reply
?
Kyle
yes I'm doing my masters in nanotechnology, we are being studying all these domains as well..
Adin
why?
Adin
what school?
Kyle
biomolecules are e building blocks of every organics and inorganic materials.
Joe
anyone know any internet site where one can find nanotechnology papers?
Damian Reply
research.net
kanaga
sciencedirect big data base
Ernesto
Introduction about quantum dots in nanotechnology
Praveena Reply
hi
Loga
what does nano mean?
Anassong Reply
nano basically means 10^(-9). nanometer is a unit to measure length.
Bharti
how did you get the value of 2000N.What calculations are needed to arrive at it
Smarajit Reply
Privacy Information Security Software Version 1.1a
Good
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get the best Algebra and trigonometry course in your pocket!





Source:  OpenStax, From matlab and simulink to real-time with ti dsp's. OpenStax CNX. Jun 08, 2009 Download for free at http://cnx.org/content/col10713/1.1
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'From matlab and simulink to real-time with ti dsp's' conversation and receive update notifications?

Ask