<< Chapter < Page Chapter >> Page >

Technology

Grade 7

Transport

Module 5

Launching the rocket

Assignment 1:

Options for launching the rocket

[lo 1.11]

Option 1

  • Use a stiletto or a sharp object, like a pair of compasses, to pierce a small hole through the length of a cork. Push the wide end of the air valve into the plastic tube. Push the other end of the air valve through the opening in the cork. You can try in a similar way to affix the air valve to the bottle-top. Half-fill the bottle with water .The water is the “propellant”. The compressed air above the water will provide the energy to force the rocket forward. Hold the intact bottle and push the cork with the air valve into the opening of the bottle. Push it in properly so that the cork cannot slip out of the opening. (You could rub some petroleum jelly [ Vaseline ] onto the cork, so that it will slip out easily during the launching.)

Option 1

Attach the other section of the plastic tube to a bicycle pump. Turn the rocket so that the right side points upwards. Make it stand upright on the base. You are now ready to launch your rocket. Find a flat launching platform away from trees and buildings. Make the rocket stand firmly on its tail fins and have everybody stand at a distance (± 5 m). Start pumping. Air bubbles will rise through the water. When the pressure inside the bottle is high, the cork and the water will be forced out at the opening and the rocket will shoot into the air. Be careful not to bend over the rocket. Only the teacher and the learner involved should stand next to the rocket.

Option 2

For the teacher:

The launching device provides a safer option. The rocket can be launched vertically from it and the device also keeps the rocket from falling over. It is, however, necessary for you to build this launching device. You also have to test the device beforehand. (The launching fins then do not really serve their purpose.)

Option 2

Launching device

Launching instructions :

  • Find a flat surface outside, away from trees and buildings.
  • Half-fill the bottle with water.
  • Turn the launching device at an angle and move the mouth of the rocket (opening of the bottle with water) over the wheel valve. Press the Perspex sheet round the neck of the bottle so that it will help the rocket to stand upright.
  • Pump air into the bottle with a foot pump not exceeding 40 psi.
  • Stand back ± 5 m and pull the Perspex sheet out.
  • The rocket should shoot vertically into the air. Do not allow learners to crowd around the rocket while it is being launched. Keep onlookers at a safe distance.

Assignment 2:

To calculate how high a rocket can fly

[lo 1.13]

Do you know that you could use a mathematical formula and scientific pocket calculator to calculate how high your rocket has travelled? How? Calculate the angle at which the rocket has soared.

Mathematical calculation: tan<A x adjacent distance = height

e.g. tan 75º x 4 m =

Try to launch your rocket three times and record your observations in the column line linear graph below:

evaluation

Assignment 3:

[lo 1.12]

Evaluate the appearance of your rocket after the first flight/launch with reference to the questionnaire below by putting a tick in the appropriate column next to the corresponding question. Try to make the improvements/changes if necessary to ensure more height during the 2 nd and 3 rd launches.

Yes, definitely Yes Uncertain No
1. Is the conical point straight? (If it is skew, it will cause unequal airflow from the point to the tail, which will result in more resistance.)
2. Is there a smooth joint between the conical point and the body of the rocket? (If the diameter of the conical point is larger than the body, it will cause the airflow to be irregular, which will increase the air resistance.)
3. Is the body of the rocket nice and smooth? (Any surface of the rocket, which is not smooth, will increase air resistance.)
4. Are the fins mounted straight and firmly? (Skew launching fins could hamper the launching of the rocket and could cause the rocket to be skew during flight.)
5. Are all the launching fins of the same size and are all the other fins also of the same size and do they have smooth edges? (Fins of different shapes and sizes cause more air resistance.)
6. Has the finishing been done very well and is the rocket sturdy? (A rocket that is not sturdy and properly finished off, also increases the air resistance.)

Assessment

Learning outcomes(LOs)
LO 1
Technological processes and skillsThe learner will be able to apply technological processes and skills ethically and responsibly using appropriate information and communication technology.
Assessment standards(ASs)
We know this when the learner:
Evaluates :1.12 evaluates the product or system based on criteria linked directly to the design brief and some of the specifications and constraints, and suggests improvements or modifications;
1.13 evaluates the efficiency of the plan of action followed and suggests improving future plans;
Communicates :1.14 presents ideas (in a project portfolio) using two-dimensional or three-dimensional sketches, circuit diagrams or system diagrams.

Memorandum

Assignment 1

Learners can help each other to carry out option 1. A maximum altitude is the main objective at each launching. The learners and the teacher can observe which rockets achieve a maximum altitude, e.g. ± 70m, and which as less effective.

Assignment 2

The teacher can deduce from the learners’ mathematical computations whether the learners are able to calculate the altitude reached by their rockets. Each learner’s line graph and flight trajectory will differ.

Questions & Answers

what is variations in raman spectra for nanomaterials
Jyoti Reply
I only see partial conversation and what's the question here!
Crow Reply
what about nanotechnology for water purification
RAW Reply
please someone correct me if I'm wrong but I think one can use nanoparticles, specially silver nanoparticles for water treatment.
Damian
yes that's correct
Professor
I think
Professor
what is the stm
Brian Reply
is there industrial application of fullrenes. What is the method to prepare fullrene on large scale.?
Rafiq
industrial application...? mmm I think on the medical side as drug carrier, but you should go deeper on your research, I may be wrong
Damian
How we are making nano material?
LITNING Reply
what is a peer
LITNING Reply
What is meant by 'nano scale'?
LITNING Reply
What is STMs full form?
LITNING
scanning tunneling microscope
Sahil
how nano science is used for hydrophobicity
Santosh
Do u think that Graphene and Fullrene fiber can be used to make Air Plane body structure the lightest and strongest. Rafiq
Rafiq
what is differents between GO and RGO?
Mahi
what is simplest way to understand the applications of nano robots used to detect the cancer affected cell of human body.? How this robot is carried to required site of body cell.? what will be the carrier material and how can be detected that correct delivery of drug is done Rafiq
Rafiq
if virus is killing to make ARTIFICIAL DNA OF GRAPHENE FOR KILLED THE VIRUS .THIS IS OUR ASSUMPTION
Anam
analytical skills graphene is prepared to kill any type viruses .
Anam
what is Nano technology ?
Bob Reply
write examples of Nano molecule?
Bob
The nanotechnology is as new science, to scale nanometric
brayan
nanotechnology is the study, desing, synthesis, manipulation and application of materials and functional systems through control of matter at nanoscale
Damian
Is there any normative that regulates the use of silver nanoparticles?
Damian Reply
what king of growth are you checking .?
Renato
What fields keep nano created devices from performing or assimulating ? Magnetic fields ? Are do they assimilate ?
Stoney Reply
why we need to study biomolecules, molecular biology in nanotechnology?
Adin Reply
?
Kyle
yes I'm doing my masters in nanotechnology, we are being studying all these domains as well..
Adin
why?
Adin
what school?
Kyle
biomolecules are e building blocks of every organics and inorganic materials.
Joe
anyone know any internet site where one can find nanotechnology papers?
Damian Reply
research.net
kanaga
sciencedirect big data base
Ernesto
Introduction about quantum dots in nanotechnology
Praveena Reply
what does nano mean?
Anassong Reply
nano basically means 10^(-9). nanometer is a unit to measure length.
Bharti
do you think it's worthwhile in the long term to study the effects and possibilities of nanotechnology on viral treatment?
Damian Reply
absolutely yes
Daniel
how did you get the value of 2000N.What calculations are needed to arrive at it
Smarajit Reply
Privacy Information Security Software Version 1.1a
Good
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get the best Algebra and trigonometry course in your pocket!





Source:  OpenStax, Technology grade 7. OpenStax CNX. Sep 10, 2009 Download for free at http://cnx.org/content/col11032/1.1
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Technology grade 7' conversation and receive update notifications?

Ask